Search results

  1. G

    8.30/22 Rims

    I put 9.5x22 tires on my L1501. The tractor sits a little higher than normal. And you may have to run a different gear when mowing etc.
  2. G

    B1500 PTO speeds and implements

    I think that most equipment is geared for 540 RPM input.
  3. G

    L1500 PTO

    I read somewhere that it is 13 HP.
  4. G

    L240 help

    [I]nfo here. http://www.tractordata.com/
  5. G

    Grass cutting advice L1500

    Most equipment is geared to run at 640 RPM. This is equivalent to 1st gear on your L1500.
  6. G

    compression release cable

    I was able to free my comp release cable up by removing it and pouring a rust remover down inside. Just keep working at it. I had to weld a bolt onto the handle end for something to grip. G
  7. G

    L1500 service or repair manual

    Those drums are pretty robust. You can hit them fairly hard. I had my local brake repair shop re-shoe and turn the drums. Now the tractor stops like it should. G
  8. G

    Overrunning clutch attachment is stuck

    Mine had a roll pin that goes thru the same hole the zirc fitting is in. You might try to use a drift punch and see if there is a pin in there. G
  9. G

    L185 2wd have a few issues questions

    The overriding clutch is what I put on my 1501-The same as your L185. It is much safer when you want to stop. G
  10. G

    Loader control valve? Is there a way to float bucket?

    I have one of these on my Ford 1210 : http://brand-hyd.com/catalog.htm G
  11. G

    B7200HST Hydraulics

    Yes I have the same valve. What did your guy do to fix the problem? G
  12. G

    B7200HST Hydraulics

    I have the same problem. What was the fix?
  13. G

    another bush hogging question

    I have a l1500, And I have a Howse rotary mower. I use 1st PTO gear with 5-6' tall grass with no problem. I use 2nd gear PTO with shorter grass, again with no problem. G
  14. G

    Any help for 331 zero turn ??

    You might try Eastwood. They have some plastic repair compounds. G
  15. G

    Hydraulic control valve

    I have this valve on my loader and it works fine. http://www.northerntool.com/shop/tools/product_200338991_200338991 G
  16. G

    aftermarket loader controls??

    Try this http://www.huscointl.com/index.php/site-map/ http://brand-hyd.com/
  17. G

    Hydraulic control valve

    Try this http://www.huscointl.com/index.php/site-map/ G
  18. G

    L225DT Brake drum stuck

    Use a propane torch to heat the center of the hub. Then soak it with your favorite rust breaker. Tap it with a brass hammer. It will come loose. I took mine to a local friction supply house and they turned the drums and resurfaced the shoes for ~$104.00. Now I have brakes. G
  19. G

    BX 2200 FEL weak

    Here is the husco site, lots of information on your valve. http://www.huscointl.com/index.php/site-map/
  20. G

    New to Me L1500DT

    I just go to my local NAPA store. They usualy have the correct filters in stock. As far as the ROPS go, I believe that the L175/185 will bolt right up. G