Recent content by osut362

  1. osut362

    L5030 Running out of fuel

    Next time it starts to run of fuel, stop. Remove the fuel fill cap. If it runs o.k. after removal your tank vent is plugged up. Clean the vent tube with a stiff piece of wire and you may be good to go.....Al
  2. osut362

    FEL won't go down B-7500

    try centering your 3 point lift, I had the same trouble....al
  3. osut362

    1st time with tiller

    Just curious.....where did you buy 2 gallons of wildflower seed?.....Al
  4. osut362

    Outside rearview mirrors

    I removed the outside mirrors and lights just for that reason (M9000). mine are still new and hanging in the barn.....al
  5. osut362

    Grapple

    I've had an ANBO for several years and it works great and is labor saver. Buy one as wide or wider than your tires so you can p/u stuff the full width of your tractor. I needed a 7 ft but bought a 6 ft because of price. When i skim along picking up stuff i run over some limbs and brush with...
  6. osut362

    ac unit thermostat

    you will need to know if you have an early or late m9000. mine is the late (2006) and doesn't look just the same as what is pictured in the WSM. appears from pictures in the book that the early evap. housing was a light color and mine, later type, is black. HOWEVER procedure looks to be about...
  7. osut362

    HP Questions

    flywheel, pto, & drawbar horse power on the same tractor will all be different. to get the info on your tractor look here: www.tractordata.com ....al
  8. osut362

    Japanese tecnological advancements

    horse power to pull it? yep, no problem. enough brakes to stop it? NO WAY. al
  9. osut362

    2wd vs 4wd

    4wd is your friend when using ground engaging tools. it will lower the h.p. required to pull the implement (more draw bar h.p.). you need pto h.p. to run a big mower, 4wd is not needed for mowing. i had a 50 h.p. tractor and it pulled a 6 ft mower fine. bought a 10 ft mower to use with the...
  10. osut362

    Truck Dump Insert Hoist Incease Lift?

    does your hoist work off a pto or a power steering pump? most of the p/u dump beds work off the p.s. pump. make sure it is working at its rated output pressure. it's been too long but it seems that gm pumps work at about 1,500 psi and ford is about 1300 psi...al
  11. osut362

    More Kubotas in Texas or Missouri???

    i don't have two, i have 3,,,m9000, b8200, & b7800...al
  12. osut362

    Changing rear axle seal on B6000

    take the wheel off, pull the seal out, replace the seal, put the wheel back on. it takes about 30 min total.....al
  13. osut362

    Added Rear Remotes and TnT

    you will love it....al
  14. osut362

    ac unit thermostat

    sorry this has taken so long to reply, i've been on vacation, still need help?....al
  15. osut362

    ac unit thermostat

    i have an m9000 dtc and a wsm for it. do you mean the expansion valve or the heat/ac thermostat on the overhead panel inside the cab?.....al