Recent content by damnnissans

  1. D

    Welding cast iron

    yes, pre-heat, nickel rod, covered with blanket over night heres a link to a write up on welding a cast axle housing: http://marylandcreepers.com/showthread.php?3777-My-Ballistic-14-bolt-shave-kit-install
  2. D

    2019 Plow HELP..

    this may help http://www.youtube.com/watch?v=Q_QcpfU1rOU&feature=related
  3. D

    Security from theft

    Chain and lock the clutch to the steering wheel and a rim.
  4. D

    Construction Guys

    fix the problem not the symtoms. is there excessive pressure on the outside of the wall? water leaks? drainage issue? Can you snake a couple pieces of rebar down through before you fill the wall?
  5. D

    Slips when pulling a load

    more than likely if the axle splines were worn, and would allow the axle shaft to spin freely inside the differential side gear, you would not being going around in a circle, you wouldn't be moving at all. 100% of the power would be going to the side of the differential with no spline...
  6. D

    Need info on a top link for my b7100 4x4

    I used a cat 1 on my b6100 like this one: http://www.tractorsupply.com/adjustable-top-link-category-1-0267759 unlike the cat 0 listed in the above post: fyi: I had to grind about 1/8" off the sides of the tractor-side bearing end.
  7. D

    New member question about rear axle nut

    http://www.orangetractortalks.com/forums/showthread.php?t=266 see this link that may or may not apply to your machine. is the axle spinning or just tight? try a cheater bar?
  8. D

    Hydrolisch

    translated but, check the fluid level? check the filter? check the power? Jan van Diest-- Controleer het vloeistofniveau? controleer de filter? Controleer de stroom
  9. D

    What is your day like?

    I'm 29 years old. Baltimore county and Carroll county Maryland. From 14-17, I worked on the family farm (corn and soybeans), chasing ground hogs, cutting thistle, hooking up implements, vehicle and tractor maintance, and learned to drive. From 17-20, I worked on a local family's Llama farm...
  10. D

    Mower suggestions for first timer

    I run an older 5' Mott flail on my b6100. Only complaint that I have is the amount of weigh I needed on the front of the tractor to be comfortable on the hills I have (probably steeper than yours.) I can back over a 6' tall brushy bush, drop the mower, and shred it almost completely. It nicely...
  11. D

    Post hole digger spins but wont dig

    Is anything restricting the 3PH from moving downward past the point where it stops digging?
  12. D

    Gravely Attachments

    I'm actually working on a one point hitch for the front of my b6100 that will accept Gravely 2-wheeler UNPOWERED attachments. My stockpile of attachments is getting larger by 3 this saturday. The easiest way I can see to power a Gravely attachment off a rear tractor pto is probably obtaining a...
  13. D

    What did you do to or on your Kubota today?

    picked up a flail mower this past saturday, "runs great" so after tearing the super stuck bearings out of it yesterday, today I dropped them off at the auto parts store to let them hunt some down. Not physically on my b6100, but related I guess...
  14. D

    B7100 snowblower front mount

    I am interested. Any idea on shipping to 21776?