Sunshine L1-245

Bearville

New member

Equipment
L1245DT
Sep 3, 2016
15
2
3
Quathiaski Cove
Well , been all over the wiring and have found nothing….the ram on th right side of the hitch works fine hydraulically with its manual switch , the control valve is under pressure , and I can lift the three point up and down by hand with no resistance!
But no hydraulic operation on the three point itself…
 

Attachments

Last edited:

Russell King

Well-known member
Lifetime Member

Equipment
L185F, Modern Ag Competitor 4’ shredder, Rhino tiller, rear dirt scoop
Jun 17, 2012
6,074
1,834
113
Austin, Texas
Well , been all over the wiring and have found nothing….the ram on th right side of the hitch works fine hydraulically with its manual switch , the control valve is under pressure , and I can lift the three point up and down by hand with no resistance!
But no hydraulic operation on the three point itself…
There may be a push rod between the cylinder and the arms to move the arms. It may be missing, bent, broken, out of position?

I don’t even recall how to get to it but it is in line with the piston movement.
 

Bearville

New member

Equipment
L1245DT
Sep 3, 2016
15
2
3
Quathiaski Cove
Well , I’ve scrapped the monroematic and installed a simple joystick operating the lift solenoid 2 way valves…..
leaving the hydraulic ram on the one arm to give me level control…it works like a charm, very happy!
 
  • Like
Reactions: 1 users

The dutch guy

New member

Equipment
Kubota new Sunshine L1-225
Jun 4, 2025
2
0
1
The Netherlands
I just replaced the rear wheel and cover over the filter! I also drained 3 gallons of excess fluid! …. Don’t know what the previous owner was thinking?
I just replaced the rear wheel and cover over the filter! I also drained 3 gallons of excess fluid! …. Don’t know what the previous owner was thinking?
Hi,
a question about the light in the back in this picture. How is it wired? And does it have a separate switch?
I own a Sunshine L1-225 and try to figure out how to easily install worklights.
 

Bearville

New member

Equipment
L1245DT
Sep 3, 2016
15
2
3
Quathiaski Cove
Hi,
a question about the light in the back in this picture. How is it wired? And does it have a separate switch?
I own a Sunshine L1-225 and try to figure out how to easily install worklights.
I don’t see the photo with a light…if you mean the back facing single light behind the seat it has a wire run from the ignition switch thru a on/ off toggle mounted to the left of the seat!