Ok peeps so I had a gentleman give me a leinbach auger that has been sitting for some years. After tearing it apart and replacing some small minor things I put it on the tractor and no matter which combination of pin placement I did the highest I’ve been able to get it to raise is about 1/2” off the ground. I’ve even shortened my lifting arms on the 3 point as far as possible and still the same result. I originally put it on a M7040 and after trying everything I then swapped it to the M9540 thinking that might be the issue. But for some odd reason it still does the same thing. I’ve had augers in the past and never encountered this. The others I’ve had would have close to a foot or so at full lift. I’m at a loss and have no idea what it could be. Any help is greatly appreciated.
Josh
Sent from my iPhone using Tapatalk
Josh
Sent from my iPhone using Tapatalk