Search results

Having am issue trying to find a hydraulic side link to fit in here. Any ideas? One thing i thought was order a shorter one with an upper eye then make an adapter to go from eye to eye on a slight angle.

Been working this project piece meal. Gets expensive quick. However finally completed install of rear remotes. I did have to pick our good friend Dan's brain to confirm connections. So thank you again Dan.

No matter how heavy you think something is built, it's still breakable. 10 ton peterbilt single axle dump. Not what I exactly what I wanted to do this weekend. 🤦‍♂️

Had this sitting around for a few years, finally decided to start picking away at it. Continental y69 flat head 4 cyl. Wrapped in farmall metal. Was used to power pull behind international harvester balers and combines. Got the plugs out and started soaking pistons. Locked up tight. If I can...

Last couple rainy weekends got me bored. Removable skis in case they wear out, attached with button head bolts so dirt doesn't build up. Cutter blade from king cutter and rippers from tractor supply. With those parts, steel,epoxy primer and kubota paint; little over 1k in it.

So I ordered a spare tire bracket, Ounyoizs brand, for the trailer from Amazon. Appeared fairly well made and it actually is. However the bolts they give you to mount the spare are 10x1.50 thread. Noone makes a lug nut that size. I ended up drilling out the 2 mounting holes I would need and...

I had a bolt fall out of front axle holder on my b2400. This allowed the holder to spin which snapped the pinion shaft where it connects to the propeller shaft. What is involved in changing this out and what should I order to replace other than the pinion itself? I see on messicks.com diagram...

I changed bucket control valve back a few months ago while chasing loss of lift. Thanks to Dan finally traced it to a weak pump. Anyhow I haven't used 3pth since changing the valve. I've had ballast box on and 3pt valve locked. Yesterday, after installing new 3pth fast hitch I had no lift on...

Needed to add tool box. So I welded up some steel I had laying around, 2 u bolts from tractor supply, and a $22 tool box from Amazon. Not including paint about $35.

So while mowing Saturday on zero turn, cruising along suddenly it sounded like the entire deck was self imploding. I immediately turned off deck drove to the garage and found right outer blade was missing half its blade. I did not hit anything in recent memory and blades had been wire wheeled...

B2400 la252 loader. Loader works great for about 45 minutes the starts getting slower to lift. New loader control valve didn't solve it. Ideas will be much appreciated.

I have a b2400 hst and I am having an issue with power steering leak. I have the h11501 steering controller. I have changed the top seal twice with no luck. I have now found there is another seal inside. Number 360 on part listing. Has anyone dealt with this before and if so what else should I...

I finished repairing my 3pth hydraulics on b2400. New control valve, new seat poppet and spring in relieve valve. I measured the shims that came out and replaced with new. Actually have slightly less shim now than was in there. My question is the relieve valve is popping at 2000psi. Factory...

I have now downloaded 2 wsms from 2 different sites for my b2400. They both cut off he Last several pages. Ironically these are pages dealing with the hydraulic cylinder case for 3ph which I am working on. Does anyone have the needed info?

Having an issue with b2400 front rear leaking bad at the swivel joint. Changed the seal about 2 months ago and is leaking bad again. Any ideas????

Hi. Brand new here. Recently picked up my b2400. Got it for a great price, hst was blown up. Good used unit from Kentucky tractor and I'm up and running. I was just wondering if anyone had an idea of approximately what yr it may be. Serial number 70823. Thanks