SORRY FOR THE BOUT of DYSLEXIA my loader is a LA 364 not a 346, you cant edit the header
Started accumulating some parts for my SSQA project and since all the factory backing plates and attachments seem to have the narrow "case" holes @21"OC I'm thinking of using this spacing for mine. By using this spacing it will allow my bucket brackets to weld right onto the latch plates without a standoff and keep the pin to back of bucket distance almost stock. I think I will also section the back plate so its only as wide as I need it and not to the full 45" ssqa std.
I drew in apx where the brackets will go by using the case specs.
Started accumulating some parts for my SSQA project and since all the factory backing plates and attachments seem to have the narrow "case" holes @21"OC I'm thinking of using this spacing for mine. By using this spacing it will allow my bucket brackets to weld right onto the latch plates without a standoff and keep the pin to back of bucket distance almost stock. I think I will also section the back plate so its only as wide as I need it and not to the full 45" ssqa std.
I drew in apx where the brackets will go by using the case specs.
Attachments
-
95.7 KB Views: 686
Last edited: