I'm scraping off an area and want to move the dirt to another area to fill in with a 4ft box blade and a L1500.
When i get to where i want the dirt i'm thinking just bump the TPH up a little and let the ground pull the dirt out of the blade evenly.
Problem is i can't seem to only bump the blade up a hair or two. The pump moans, groans and whines at me and then it comes up way to far before i can stop it and i end up with a pile of dirt left behind not an even stretch of dirt.
Am i going about this the wrong way or do i need more practice or is something on the tractor not working right?
Should i set the stop on the bar closer? I don't even know if that's proper terminology to convey my thoughts.
When i get to where i want the dirt i'm thinking just bump the TPH up a little and let the ground pull the dirt out of the blade evenly.
Problem is i can't seem to only bump the blade up a hair or two. The pump moans, groans and whines at me and then it comes up way to far before i can stop it and i end up with a pile of dirt left behind not an even stretch of dirt.
Am i going about this the wrong way or do i need more practice or is something on the tractor not working right?
Should i set the stop on the bar closer? I don't even know if that's proper terminology to convey my thoughts.