I split my newly purchased b6100 in half to do a clutch. I also purchased a new pilot bearing as I figured it would be good to replace it while I was in there. Unfortunately both of my propeller shaft and the inside of my crankshaft where the pilot bearing goes are completely worn out. It appears I will be purchasing a new propeller shaft and either having this crank machined or possibly replacing the crank! Thae rear main seal is also wiped, to add insult to injury someone else had been in here previously and cross-threaded one of the bolts for the flywheel so of course that broke upon removal. The good news is a team of two of us was able to split the tractor in half from running to completely disassembled in less than 48 minutes! Now my hunt for parts begins! Anyone else that has had experience with this issue feel free to chime in.
Attachments
-
95.1 KB Views: 187
Last edited: