Search results

I'm sure this has been asked and answered before, but none of my searches had positive results. I have a B2301 with MMM and typically run it around 2200 rpm when mowing. I generally run it in low range (and pedal not quite to the metal), because I mow 99% on a hill. What do others run when...

I have a B2301 with about 70 hours on the meter. I just removed the MMM for winter storage. I moved the PTO lever from mid to rear and ran PTO for a minute or so, then back to mid PTO. Seems a lot smoother and quieter on rear vs mid. With the mower engaged, you'd never know the difference...

I've been reading up on all the posts related to doing the initial 50hr maintenance and have been intrigued with the shop vac oil trick. After reading about oil getting sucked up in vac, and what hp to limit to, etc., I decided that I needed to provide a way to vary the amount of suction. I...

I'm looking at a B2150 that has a 72" mower deck. The deck looks way too close to the rear tires, and even has black rubber marks where it has hit the tires. I can see a little forward/backward adjustment, but not much. Is this deck just too big for the tractor?

I know I saw this once before, but I've been searching for the last hour and can't find it. Lots of posts on loose hubs, but nothing about the bolt torque. My hubs seem to be OK, and no visible wear as I've seen in some of the posts. I just want to torque to specs. I've looked through the...

I've been checking all the bearings, bushings, etc., on my RC60-72 mower deck and noticed that the tension pulley was off line a bit. Upon removing the arm, it was obvious that the spindle welded into the deck was worn to the point where it should be replaced. Has anyone removed this before...

Just checking to see if anyone out there happens to know the part number for a B7200 brake shaft oil seal. These are dry brakes...supposed to be. Ordered a new one from local Kubota dealer, and after a week of waiting, found that it was not the right part. You can see the pictures of the...

I recently bought a B7200, and am currently doing some initial inspections, repairs, and general replacing of anything that looks questionable. One in the questionable category is the control lever for the 3-pt hydraulics. The lever was bent to heck, rusted, and looks like someone did a quick...