Search results

Got an early b7100 with high low transmission. Couldnt figure why I had a gap between hood and dash till I measured the column and it appears the older models had a column 1 " shorter than the HST model. Anybody with an early B7100 column they want to sell? Dont care about the box just need a...

Anybody tried swapping out the steering box assembly from a b7100 to a b7000? everything appears the same but not sure if the drag link joint is the same size. Maybe one of you guys has tried this before.

Got a b7000 with a cracked steering box. Need the box itself or would be willing to buy the whole thing if that what it takes. Any luck? Damon

Recently bought a 48" BB2048 Frontier box scraper. I have the lower arms for the 3 point but not the top link. As I measure it out the distance from the top link hole to hole is 25 inches. That seems really long to me could that be right?

Need set of rear axle shafts for the B7000. Any luck?

Got a nice instrument panel for my B6100 but it appears its really for a b6000. One obvious difference is the regulator. Is the b600 regulator usable on the 6100 or should I swap them? Looks like they bolt on diffently.

The Steering wheel on my b6100 is really stuck on. Any ideas on how to remove it? Ive tried a gear puller but cant get the jaws around and under the center of the wheel. The center nut is off. Is it a spline fit?

Any chance someone out there might have these parts in good condition for sale? Thanks in advance!

I have been unable to remove the brake hub on my B6100. Heat and a gear puller moved it a few millimeters but thats all. Is there another way to get the hub off? Can I take off the whole gear housing on that side hub and all and attack it from the back side?

Figured Id do the brakes on this B6100 not expecting any surprises but when I took off the housing covering the brake shoes out poured transmission oil. Is this a common problem? Never had this happen on my B7000. Still trying to get off the drum but Imagine its a seal behind the drum. What a mess.

My kubota B6100 needs all the front loader hoses replaced. Does anybody know what size they are or how to size them? I am sure I need to get them from an aftermarket place but dont know how to size them. Thanks!

Are the after market clutch kits for the 6100 any good? been looking for genuine kubota but so far no luck.

Just picked up a B6100 that I have been wanting for some time. Does anyone have a recommendation for a box scraper that would work on this tractor? It has the 3 point I think its catagory 1. Also has a loader if that makes a difference. Thanks!

Willing to part out let me know what you need. Lower end completely rebuilt. bought another tractor so dont need this motor. Slim

I have a xZ650 engine I am parting out. Id sell the whole thing but I dont want to get into shipping it as such. Many good parts on it let me know what you need by writing at rustyrestos@charter.net Thanks Jeff

Anybody know what the torque setting should be for the B7000 headbolts? Much appreciate any advice, Rusty

can somebody tell me how to do this? Its on a B7000 but Im sure other small tractors have the same bushing. Its so thin I cant see pressing it out. Ideas?

Has anyone here actually done a complete rebuild of the Z650 kubota engine? Thats the B7000 motor. Id like someone with first hand experience to tell me any particular difficulties they might have had or things to watch out for. Also, where can I find the governor springs? Not a kubota dealer...