Search results

Did a little bush hogging today. Mostly heavy grass and tall weeds. Heavy grass had not been cut in a couple of years. The weeds were on a vacant corner lot and some were 6’ tall. Had to go slow because of the thickness and wasn’t familiar with the property. Lx2610 does a good job of...

Water in fuel??

Cleared the trail down to the Ohio river for a customer. Then cleared an area beside the river.

👍

The spring loaded pins at the end of the arms go in the stainless clips above the arms.

That doesn’t sound right. On first start up I’ll preheat with glow plugs for 10 seconds. It usually starts on first try.

I had a bh65 on a b2620. It had 1 swing cylinder. You couldn’t sweep spoils into trench/hole. Does the bh70 have 1 or 2 swing cylinders? The bh77 has 2 swing cylinders. Much better setup.

Did a little bush hogging with the LX2610 and Woods bb48.

This from Friday. Landpride rtr1258

I owned a 2011 b2620tlb. You will be better off with an 18’ trailer with brakes on both axles. It was a tight fit on a 16’ trailer.

Put your pto selector in the mid pto only slot. The farthest to the front slot. If that doesn’t rotate, slide the selector between the front selector slots and try to rotate the pto shaft. WITH THE ENGINE OFF!!

So, what happened to your grapple?

I just looked at Lowes, and their highest price was $47 for 32 oz of concentrate.

Go to your local O'reilly's and rent a 3/4" ratchet and socket.

My BB48x has been pretty tough. It is almost ten years old. It cuts really heavy brush one day. Then the next day it cuts heavy grass and it looks almost like a lawn. I have had good service out of my little 48” brushbull.

Switch the hoses on the third function valve body. There should be 2 hoses with flat faced couplers on the top of the valve body.

No grease fitting for the hst. Just 1 for the brake pedal.

Who installed your 3rd function valve? What brand is your 3rd function?