Search results

You mean my stubbornness 😄

I didn’t get his name from this forum. I picked him because of his price. Valuable lesson learned. If you use a seller recommended by others here, you’ll be fine

I can’t find the guys card, but I ordered it on ebay…I will check tonight. Great questions… It’s possible I failed in the adjustment, but I was very careful, my son 3d printed a jig to set them. The aftermarket fingers were all different heights too. Plus there was an obvious difference in...

This model has 3 fingers that must be all be within a specified distance from the flywheel face.

I hope not 😃

I just took the B7100D out for a test drive. Months ago, the clutch went out (of course soon after I bought it). Never had a tractor and never worked on one. Got out the manual and split the tractor, ordered aftermarket and replaced the disk, pplate, TO bearing and some seals. I adjusted...

When I bought my B7100d, the 3pt control valve (not sure if this is the same control valve Wolfman referred to) was seized (no surprise, my hydraulic fluid was basically water). This was the first thing I tackled. Removed it, partially disassembled it and soaked everything in a bucket of ATF...

I’ll PM you with my number.

This back half is actually my original one. I replaced it with an even better one, more complete with the rollover bar too! Do you need the 3pt control lever? Is yours stuck? I can sell you mine, but honestly, since you need to remove it anyway, just take yours apart clean and oil it really...

I can appreciate that. This will be the split number 4. First, I put the TO bearing in backwards, then turned out it was the wrong TO!

Months ago, I replaced my clutch components with aftermarket brand parts. They all appeared to match the old ones. The TO bearing is a Timken (Timken has always made great bearings). I followed the manual when setting the pressure plate finger heights. After running for about 4 hours, the...

I have the back half (bell housing to 3pt) for parts. The unit functioned as it should, before I removed it. Anything you need, just ask. I do not have the seat, wheels or hubs. Prices to be negotiated, plus shipping.

Yes, do you need the housing and the internal parts?

Here’s a few pics. Do you need the battery tray/fuel tank holder/tool box? Or anything else in the pics…I also have rear fenders, but one has some rust.

Yes, dash still attached. I will get you some pics. How about $100 plus shipping? We are getting ready to go ona vacation Saturday. So if I forget, just call me. I will PM my phone number.

I have a steering wheel and column an entire rear half (except seat, fenders, wheels, tires). B7100D non-hst

A few auto parts stores make custom hydraulic lines, especially the ones in farming areas. Autozone comes to mind.

Will a D1105 “fit” in a B7100D non hst? I might be able to get one with a bad injection pump. Looks like they have about 22hp. It would be a back-up engine. Model D1105-BG-ET01 Looks like the oil pan is taller and the overall length is longer, center of crank to bottom of pan is taller. And...