Search results

SOLD ------ Moderator please remove this Post

Still for sale.

A gear drive b7100 does not have a mid PTO. If by "MST" you reference above is actually HST then you have a hydrostatic transmission. (forward/ reverse controlled by a foot pedal) The HST version of the B7100 does have a mid PTO that can operate a front mount snow blower.

What you really need to know is what model sub frame will fit your tractor. Two that I know of: B2652 subframe with a B2650 or B2660 snowblower. (I happen to have one for sale in classified section) B2733 subframe with a BX2750 or B2781 or B2782 snowblower.

Try Miller tire Miller Tire

Kubota B2660 front mount snowblower. 5 feet wide. Good condition. Includes B2652 subframe, mounting hardware and drive shafts. Manuals Included. Some scrarches in paint that have a little surface corosion but no serious rust. You can leave the subframe on the tractor while using a front end...

NHS = Not for Highway Service I put new front turf tires on my B7500 a couple of years ago. I had no problem finding them. Ordered from Amazon if I remember correctly.

Don't forget to put some grease on the splines before assembling. Without grease the splines wear down, No replacement parts available.

You need to lock the nut to the center part of the lifting rod. Turn the nut in one direction while turning the center in the other direction. Like jamming two nuts together to keep them tight.

Try drilling through the pin with a carbide tipped masonry bit. I have used this trick when a drill bit has snapped while drilling to use an easy out.

If the clutch is stuck to the flywheel sometimes just driving around with the clutch pedal down and keep stabbing the brakes will free it. Chaining the tractor to a tree and driving away will sometimes work if you keep the clutch pedal down while driving. Most of the time it requires splitting...

Part #250 located on right front of engine.

After looking at Bill's post I guess I did not recall the correct side that the drop speed adjustment is on.

A B7100 does not have the knob to control the drop speed in the position that we are all accustom to finding it. Instead of a knob to turn, it is a bolt head on the top of the differential case under the seat. If I remember correctly it is on the left side (as viewed sitting in the seat) . I...

I had a b36 tiller. It did a great job. Wish I had never sold it. I think your tines are worn down. I sold it a long time ago so I don't really remember what the tines looked like. What I do remember is it worked great.

My B7500 has a mechanical stop rod to shut off the fuel to stop the engine. So no electrical fuel controller to shut off the engine. It also has a mechanical fuel pump so it only creates fuel pressure to the injector pump while the engine is turning (cranking or running).

It is called an "oil Galley" plug. It happened to me with a B7100 I once owned. Check out this thread oil galley plug for suggestions.

When I installed the heater on my B2410, I cut into the little bypass hose, installed adaptors to change to 5/8" heater hose. Ran the 5/8 hose to a valve like this PYPASS VALVE then into the cab heater. Easy to do and it works great controlled by a choke cable I installed on the dash. The bypass...

Are you in high range or low range when this noise happens? If in high range I would consider it pretty normal,

If a B9200 is wired like a B7100 (I would assume it is), then yes they are wired in series and if the indicator burns out the glow plugs will not work when the key is turned to the pre heat position. They will work when the key is turned to the start position as this key position bypasses the...