Recent content by JasonY

Thanks! They look excellent! Did you have to go through several trials to figure out which rubber mat to use from McMaster or do you have a specific one?

Question: what's the bolt for on the HST pedal side? To hold down the mat?

I've never tried steering wheel spinners. They seem like they'd be arm-breakers, especially if the wheel is farther away like it is for us tall people. From your experience, do you like using one? I have all of 5 hours on my tractor so it's not like I have a lot of experience, and they're not...

Any chance of you sharing those files? I have a 60 watt ULS. Barring that, how about selling the floor mats themselves? I imagine you'd have quite a few buyers here.

I work with college students and 90% of them either have no symptoms or very mild. A very few of them have bad colds and only a tiny handful are laid up in bed for several days feeling miserable. 100% of them have recovered completely.

Just an update. I went a-tractorin' today and checked the RPM. Max was right at 2200 as everyone here said. Looks normal!

Oh wow, thanks so much for the note. On the one hand, it infuriates me that something so simple would be consistently missed. That tells me that *every* similar tractor has the same assembly mistake by the same tech. That's unforgivable. But if you have 30 hours on it and it's okay then that...

When the guy dropped it off the other day and did the walk around he was unable to find the drain valves for the front axle. He said "I don't really know these that well". He also said "I guess you siphon it out?". He also said "most of these come with fluid from the factory. I was...

My L2501 was delivered the other day from the dealer (Ewald Kubota in Georgetown Tx). The delivery guy also did the initial assembly and fluid install. I asked him about the front axle and he said that they come pre-filled from the manufacturer. I asked him to show me the drain plug and he...

3.3 hours on the L2501. Just got it delivered 3 days ago and it's temporarily living on some friends' property until we get our metal building finished. We went out there and greased the zerks just to get familiar with it, and I..... dusted it off. Don't judge me, it's still new! Also covered...

COmment of the day. That really made me smile. :)

Man, I feel you there. We currently live 20 miles from the property and are out there all the time. Just finished the fence and will start on the road and electrical asap, then the metal building and septic, THEN I'll be able to put the tractor inside, not outside where my friends' chickens and...

"I'm not sure if you got 2400 out of it or not. I think max is supposed to be 2200. I'll jam mine full throttle at times when needed and I am not sure if I ever made it to 2400. The engine has been limited to lower RPMs on the 2501 so as not to exceed the 25 hp threshold for the Tier IV...

Just got our 2501 yesterday and I had to drive it about 1/2 mile down the road to get to our property (it's being stored at a friend's house since our property isn't developed yet). The RPM gauge maxes out at 3200 RPM but even fully open and running down the road in High with my foot on the...

Did you get the 1 to 2 adapters and slide them into the 2 to 3 adapters? I was worried since the ID of the large adapter was 1 1/8" and the OD of the small adapter was 1 1/8". If it's too exact then it's a pressure fit (and I don't have a press).