North Idaho Wolfman

I spoke with you last week (or 2) regarding my stuck 1140 injection pump. I finally got it out, had a broken spring and one corroded plunger. It's back in and running, thanks for your help. I took the anti tamper screw out hoping it would make getting the pump out easier. It didn't help, I'm wondering how to set the screw adjustment properly again, and learn it's function.
Thanks again,
Seann

Wolfman You once helped me with a throttle problem. Now it's steering.
I read a post that was virtually identical to mine, but he never said how it turned out. I'm not sure how to contact him with a PM. My tractor is 1998 L2900 DT, 4wd, FEL 643 hrs. Won't steer to right. FEL and 3 point works. Steers left but weak. With engine OFF and I turn wheel to right, I hear fluid squirting, and then I see fluid dripping under tractor. Found a rats nest under the steering column by firewall and I suspect he chewed a hole in the right turn hose. My plan is to order two hoses and 2 flare nut male to male connectors, color tape them for identity, disconnect them from the steering cylinder and pull the old hoses out and the new hoses should follow right behind. There is another hose, I assume is supply from the pump to steering controller and another that just has a simple hose clamp. Should I replace all 4? They're kinda pricey. Where does the low pressure hose go? Is my plan sound?

Will a RC60 21b fit my HST 7200 ?? Thank in advance as you are always helpful

Wolfman, do you know this guy? (Hi I'm Mike the pump guy.. I read on the forum u need your pump o/h'd..
I do them all day long for 410.00 w free return shipping..
I've been rebuilding inj. pumps for a living at a fuel shop for over 30 years..
to say I've done "a few" is an understatement.. lol
actually its more like thousands..
I'm factory trained & only use OE parts..
If u would like to discuss it further, u can reach me direct at.. thepumpguysc@aol.com
Thanks for your time.. Mike

NI WOLF MAN could u take a look pls at my last ? & let me know what u yhink pls thanks for your help

how are u wolfman tractorprojohn here u helped me a while back with 3 point would only work when bucket was being curled up & again thanks so much ok it turned out had a hydr line crisscrossed 3 point works fine now with the ( FEL )attached but when i disconnect the loader & turn the split on front hydro block 3 point does nothing hook the loader back up turn slit works fine !!when loader is dis connected i tried it turning the slit on frnt h block 7 o clock or like 11.20 nothing !!any ideas thanks for your time in advance tractorprojohn L 2850

N I WOLFMAN have u had a chance to take a look at my posts on myL2850 3 point wont raise unless bucket is being curled upward,,& hydraulics bind up when lift & draft levers ( on right side of seat ) are almost all the way up or torge t rear of tractor

Wolfman - Have you seen any fabrication attempts to convert another blower for use on a 3600? I found the mount, but not the blower. Appreciate your thoughts! Thx

Don't ban me for scolding someone, please!

I have a Kubota 4310E tractor no FEL. What type Hydraulic fluid should I use. I saw a video on this site stating I could use TSC Premium Hydraulic Fluid. All help Appreciated