North Idaho Wolfman's latest activity
-
North Idaho Wolfman replied to the thread Brake Not Fully Releasing BX2370.There is not a lot to the brake or linkage on that model. Check for this spring. -
-
North Idaho Wolfman replied to the thread New LX2620 Driveshaft rattle?.You have to split the tractor to inspect or replace any of those parts.
-
North Idaho Wolfman replied to the thread 2014 RTV1140CPX Trans Issue?.Does the motor have rpm or are they lagging? If the motor is reaching full RPMs yet it isn't moving then it a drive issue. If the motor...
-
Computer showed a fault. It was repaired and reset. Cost was @ half of a replacement and unit was returned in about a week. Thumb...
-
North Idaho Wolfman replied to the thread Purchasing a 2005 BX2350 to replace a 1988 7200 4x4.It a downgrade in size and usable weight. Yes my b7100 is not a looker by no stretch, it's missing a bunch of panels, but it works like...
-
Well one other thought on it is maybe it overheated? I don’t know why that would keep it from starting now or why it continued to run...
-
North Idaho Wolfman replied to the thread So if no one knows, who does ? As recommended posted video.You need to make a video / audio of the noise post it on Youtube, then give us a link to see / hear what's going with it. Being a cabbed...
-
North Idaho Wolfman replied to the thread M9960D trans noise question.There isn't an obvious issue with that model. You need to make a video / audio of the noise and post it on youtube and give us a link to...
-
North Idaho Wolfman replied to the thread B8200 hst d trans case.You need to be very specific in your verbiage, there are mutiple "cases" in the rear end on that tractor. Here are just a couple:
-
-
North Idaho Wolfman reacted to lynnmor's post in the thread Kubota B2400 - Oil drain plug directly above loader bracket?? with
Like.
Yep, fire up the old CAD system (Cardboard Aided Design). You might want to install a Fumoto type drain valve for future use. -
North Idaho Wolfman reacted to BXHoosier's post in the thread Show us your Shop and Equipment with Love.
Almost finished with my cutter grinder and sharpened a couple endmills to try it out. Went to a swap meet Friday and bought a few...
-
North Idaho Wolfman replied to the thread Daily Chuckle.Now that sucker is going to rattle around in there and make you go nuts!
-
Over the years I see a lot of jokes about 10mm sockets. Never really got them. Well today I was changing out a tensioner pulley and it...
-
North Idaho Wolfman reacted to GrumpyFarmer's post in the thread EDC question ( Asking for a friend) with Haha.
Oh my…Id have trouble concealing that in my French cycling outfit…no one would believe that. 😉
-
North Idaho Wolfman replied to the thread EDC question ( Asking for a friend).I've got a guy in Uzbekistan that's got a hacksaw and a hammer. he'll fix you right up. :sneaky: Go down south to get the good tooling...
