Go Back   OrangeTractorTalks - Everything Kubota > Members List

VIP Service Tech

North Idaho Wolfman North Idaho Wolfman is offline

Visitor Messages

Showing Visitor Messages 1 to 10 of 19
  1. tractorproJohn
    2 Days Ago
    how are u wolfman tractorprojohn here u helped me a while back with 3 point would only work when bucket was being curled up & again thanks so much ok it turned out had a hydr line crisscrossed 3 point works fine now with the ( FEL )attached but when i disconnect the loader & turn the split on front hydro block 3 point does nothing hook the loader back up turn slit works fine !!when loader is dis connected i tried it turning the slit on frnt h block 7 o clock or like 11.20 nothing !!any ideas thanks for your time in advance tractorprojohn L 2850
  2. tractorproJohn
    3 Weeks Ago
    N I WOLFMAN have u had a chance to take a look at my posts on myL2850 3 point wont raise unless bucket is being curled upward,,& hydraulics bind up when lift & draft levers ( on right side of seat ) are almost all the way up or torge t rear of tractor
  3. lakergrad
    3 Weeks Ago
    Wolfman - Have you seen any fabrication attempts to convert another blower for use on a 3600? I found the mount, but not the blower. Appreciate your thoughts! Thx
  4. D2Cat
    Don't ban me for scolding someone, please!
  5. Beaux
    I have a Kubota 4310E tractor no FEL. What type Hydraulic fluid should I use. I saw a video on this site stating I could use TSC Premium Hydraulic Fluid. All help Appreciated
  6. sparky76266
    Where can I find a front gear cover for my L235 DT Kubota it has Corroded away on bottom bolt and is leaking oil and I can***8217;t not seem to find online new or used for tractor
  7. SwampCat
    Wolfman, you posess more knowledge than any 5 dealers combined, so I ask you. I have a B7510 with a B2733 quick hitch running a BX2750C blower now. Love the tractor, underwhelmed with the blower. Looking at a BX5455HD, will it fit right up to my existing quick hitch ? If so, still trying to figure which 1/2 shaft to finish it off. Any wisdom you can offer is greatly appreciated. Thanks, Russ.
  8. Yarg
    Hello thank you for your replies how much do you figure you have into the homemade universal skid steer mount in materials
  9. Roadworthy
    Thank you for the information on chains. I'm kind of accustomed to 24" rims and kind of extrapolated numbers based on that. I saw John Deere on the box and expected it was for a larger tractor, though you'll note I did include a caveat.
  10. sparky76266
    is there a diagram of where plugs are on block

About Me

  • About North Idaho Wolfman
    Sandpoint, ID
    L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
  • Signature
    Some days you're being chased by the wolves,
    Some days you're running with the pack!


Total Posts
Visitor Messages
General Information
  • Last Activity: 3 Hours Ago
  • Join Date: 06-09-2013
  • Referrals: 0


Showing Friends 1 to 10 of 26

All times are GMT -8. The time now is 12:59 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2020, vBulletin Solutions Inc.