I have a B7100 HST-D and using a Woods rotary cutter. Yesterday I removed the cutter shaft from the tractor PTO shaft to grease the U-Joints. I noticed there are (2) locking grooves on the tractor PTO shaft. One groove is about 1/2" from the rear of the PTO and another is about 1.5 inches toward the front of the PTO shaft. I finally, was able, to get the implement U Joint to lock into the last groove toward front of tractor. Is this the correct locking groove?
The implement U joint locking system is push bolt/rod type.
Any assistance will be appreciated. thanks in advance and have a fun day on your tractor.
Wilburn "Red" Cox
The implement U joint locking system is push bolt/rod type.
Any assistance will be appreciated. thanks in advance and have a fun day on your tractor.
Wilburn "Red" Cox