Mid-mount Mower pin up LX2610

[imnukensc]

Is there a video on installing and removing the deck?

Apparently I could use a tutorial.

Don't know if there is a video, but I bet the instructions are in the owner's manual.

 

[jrsavoie]

Don't know if there is a video, but I bet the instructions are in the owner's manual.

Sometimes you can catch little things that others have learned, that are never going to be in the Manuel.

I don't last long on the ground. If I can cut 10 seconds, that just might be the difference between getting it done and taking a break

 

[je1279]

Is there a video on installing and removing the deck?

Apparently I could use a tutorial.

Here is the best that I could find.

 

[jrsavoie]

Here is the best that I could find.

Thank you.

I'll have to watch again after we get the machine back again after having the bracket that raises the deck replaced again

 

[jrsavoie]

O

On my LX2610 they did not line up as delivered. Resetup the mower deck and adjusted as needed(way off). Also drilled out the brackets and mower mounts about 1/32 of an inch, and went with a slightly smaller clevis pin for easy installation/removal. HTH's

On related notes. I am having trouble understanding everything about using the loader with the deck on the LX2610 and mowing with the deck up.

What is the loader stop pin?

So far we have just been inserting 2 pins to hold the front of the deck up.

Is that all we have to.do to use the loader and 3 point?

On page 25 of the manual, it says
1. lift the deck to the fully raised position,

2. Remove the loader stopper. Pin. Insert the pins in the holes of the mower deck and loader stopper. Then attach the snap ring.
Remove the loader stopper pin from the stay and reinstall it in the holes of mower deck as shown.
Picture 1SAPY00020A01

Can the mower deck be used in the up position? Or anywhere in between?

We have some tall grass and would like to mow higher without resetting our deck.
On all the other midmounts I've had or used. You just raised the deck up to where you wanted and mowed.
The instructions seem to indicate that you have to reset the deck wheels to the height you want to run the deck every time.

Thanks