Loader pins not fully engaging?

[J329]

New L3902. I noticed with both my pallet forks and bucket, neither of the “square things” bottom out on the nuts when I lock in the SSQA arms. On my grapple one of the two does bottom out, and that pin protrudes through the bottom of the attachments a bit further.

Are the “square things” supposed to bottom out on those nuts?

 

[D2Cat]

Show us a picture of the bottom, with the beveled piece in as far in as far as it goes.

 

[ruger1980]

When in the locked position the spring should be compressed like it is in the image.

 

[J329]

 

[whitetiger]

New L3902. I noticed with both my pallet forks and bucket, neither of the “square things” bottom out on the nuts when I lock in the SSQA arms. On my grapple one of the two does bottom out, and that pin protrudes through the bottom of the attachments a bit further.

Are the “square things” supposed to bottom out on those nuts?

There should be a gap between the nut and the block. If they were to contact, you would have less spring pressure on the attachment pins.