L245 3 point linkage problem

[philkent]

3 point linkage wont go up under load Filter is clean Good pressure from pump.Orings replaced in lift cylinder..What to do next? At the moment the 3 point will slowly rise with high revs without load

 

[hodge]

Uplifter valve sticking?

 

[philkent]

Uplifter valve sticking?

Uplifter valve sticking?

Will open it up next week and see whats in there

 

[Dave_eng]

Before taking things apart try sending a private message to " rbargeron."
He owns and has owned a number of older L's plus is very well educated technically.
It may be an issue with the feedback rod but ask Dick
Dave

 

[TheOldHokie]

3 point linkage wont go up under load Filter is clean Good pressure from pump.Orings replaced in lift cylinder..What to do next? At the moment the 3 point will slowly rise with high revs without load

How and where did you measure pump pressure and what was the number?

Dan

 

[philkent]

How and where did you measure pump pressure and what was the number?

Dan

We Took off the banjo fitting under the seat didnt measure the pressure but came out pretty strong

 

[philkent]

Before taking things apart try sending a private message to " rbargeron."
He owns and has owned a number of older L's plus is very well educated technically.
It may be an issue with the feedback rod but ask Dick
Dave

thanks

 

[TheOldHokie]

We Took off the banjo fitting under the seat didnt measure the pressure but came out pretty strong

You need a pump discharge pressure test at that banjo or the pump outlet. That test hookup is a bit tricky to make.

Or we could just keep guessing.....

Dan

 

[philkent]

You need a pump discharge pressure test at that banjo or the pump outlet. That test hookup is a bit tricky to make.

Or we could just keep guessing.....

Dan

All fixed Crap in relief valve