Mx5200 4x4 HST with 22 hours. I decided to go ahead and grease the axle points since I use it in very wet/muddy conditions. I applied grease to the front axle gear case support. It got harder with each pump. I figured it was filling the void and building pressure against the old grease. I was expecting to see grease flowing from the joint at some point. On the 6th pump I heard a pop and the pressure released.
Did I break a seal or something or did I just push some old stubborn grease out?
Also, what size is the breather plug on the front axle support. Should I see grease coming out of all the joints?
Did I break a seal or something or did I just push some old stubborn grease out?
Also, what size is the breather plug on the front axle support. Should I see grease coming out of all the joints?