Got a little practice with my loader this weekend.

mikes1165

Member

Equipment
L3901DT, LA525FL, King Kutter 6' finishing mower, 5' Bush Hog Squealer,Box blade
Jul 30, 2015
107
2
18
Mulga
I've always heard that practice makes perfect so I figured the best way to get better with my loader was to dig me a little hole. I got a lot of practice. When finished it is 80 feet long 8' wide and 6' deep in middle. Was digging down to drain culvert that had gotten buried over the years. Found it!
 

Attachments

skeets

Well-known member

Equipment
BX 2360 /B2601
Oct 2, 2009
14,209
2,860
113
SW Pa
Whoda thunk it was down that far,, keep at it and you will be reallllly good :D
 

Brazos

Member

Equipment
L2501DT
Jul 12, 2016
113
2
18
Texas
How old are you to know a culvert was buried down there in the 1800's? That sucker was deep.
 

mikes1165

Member

Equipment
L3901DT, LA525FL, King Kutter 6' finishing mower, 5' Bush Hog Squealer,Box blade
Jul 30, 2015
107
2
18
Mulga
Been living here since the 70's. Back then there was a mineral spirits plant there. Now it's part of my horse pastures. The culvert is at the bottom of two valleys that already route the water to the trench I dug. I was told the culvert was down there somewhere by someone that worked at the plant when it was operating. The water was draining to the culvert through the ground. Just had to find the end of it,just didn't know it was that deep.Just kept digging until I found it.
 

ehenry

Active member

Equipment
BX22, FEL, BH, 40" pto tiller, 42" Bushog Squealer, pto hole digger, B7300 w/60"
Mar 25, 2014
356
88
28
Canton, MS
What does the other end of the culvert look like? Is it covered like the end we are seeing?

I'm not sure where Mulga is but if you get the frog strangling rains like we get some time, you're going to need a couple loads of RipRap to keep that trench from eroding/washing and filling the culvert up with dirt.
 

mikes1165

Member

Equipment
L3901DT, LA525FL, King Kutter 6' finishing mower, 5' Bush Hog Squealer,Box blade
Jul 30, 2015
107
2
18
Mulga
Other end of culvert is open in a valley across road. Mulga is 10 miles NW of Birmingham. Going to have to work on it some more to prevent washing.
 

torch

Well-known member

Equipment
B7100HSD, B2789, B2550, B4672, 48" cultivator, homemade FEL and Cab
Jun 10, 2016
2,595
839
113
Muskoka, Ont.
Other end of culvert is open in a valley across road. Mulga is 10 miles NW of Birmingham. Going to have to work on it some more to prevent washing.
What about pouring a catch-basin piped to the culvert and backfilling to the previous grade?
 

mikes1165

Member

Equipment
L3901DT, LA525FL, King Kutter 6' finishing mower, 5' Bush Hog Squealer,Box blade
Jul 30, 2015
107
2
18
Mulga
Going to continue working on it trying to get area cleared and grass growing on it.
 

sheepfarmer

Well-known member
Lifetime Member

Equipment
L3560, B2650, Gator, Ingersoll mower
Nov 14, 2014
4,444
661
113
MidMichigan
I can't contribute anything to the culvert solutions, but you are going to fence that nice little horse away from the area until it is done? I do know that horses do the darndest things including falling in holes etc.
 

mikes1165

Member

Equipment
L3901DT, LA525FL, King Kutter 6' finishing mower, 5' Bush Hog Squealer,Box blade
Jul 30, 2015
107
2
18
Mulga
Actually I have put a piece of fencing over the culvert to keep limbs etc. out of it and surrounded it with electric fence to keep them out of it. but the culvert goes back into the ground horizontally so not much worry of falling in it. I know horses will do their best to find a way to hurt themselves.