b8200 hydraulic block

[02fordfx4]

It appears the steel line coming from the hydraulic valve on side of tractor feeds this hose them it goes into the 3pt lift.

 

[North Idaho Wolfman]

Yep that look to be the factory power beyond loop, could be used for the BH or Trencher option.

 

[twomany]

Is that PB fitting available from Kubots spares?

It must be something a bit special to have an out flow concentric with an in flow.

Might be a fun piece to machine. ;-)

 

[North Idaho Wolfman]

Yep it's a very odd fitting, I wouldn't want to have to replace it, they are very hard to find.

 

[twomany]

I just did a quick napkin sketch of a fitting/adaptor that would work. (no dimensions)

Two o-ring grooves, an external BSSP thread and an internal O-ring boss does the adaptation. Add a few crush washers. Viola! All on hex stock if I can find it.

All based on the original banjo fitting to the lift. With the addition of an "out" port to supply the PB valve. ;-)

I'm going to run the thread dimensions and come up with the final part. It seems like a perfect match to adding remotes ..... ;-)

 

[North Idaho Wolfman]

It would be far simpler and cheaper to just tap into the block that's made to tap the hydraulics just ahead of it.

 

[twomany]

The esthetic of one less pair of pipes or hoses to a remote valve may hold value to some.

 

[North Idaho Wolfman]

The esthetic of one less pair of pipes or hoses to a remote valve may hold value to some.

That it may.