B7800

[jjmcm4858]

Just removed bradco hoe ( 3375 hydraulic driven sub frame mounted) to install 3 point ( pto driven ) post hole. Need skematic for hydraulics?? Not sure which line goes where. 3 point and loader work but not forward/ reverse travel. Other hose set-up loader and traverse good but 3 point would not go up or down. . Very green at this. Thanks. James.

 

[Billdog350]

Take a picture of the setup on your machine esp where it is plumbed into your system so we can help.

 

[North Idaho Wolfman]

I'll second the pictures request.

If there was 2 lines that went to and from the backhoe then you will need to loop those two lines together.

I don't know exactly why it would effect the HST, maybe they did something odd with a suction line setup.

 

[jjmcm4858]

Take a picture of the setup on your machine esp where it is plumbed into your system so we can help.

After all that I must have gotten off machine and bumped range lever into neutral. First time taking hoe off so I was distracted and didn't notice. Silly mistake. Thank you so very much trying to help me. I usually never ask for help. Thanks again.