The lever to raise and lower the MMM and 3-point on my B7300 works fine to raise and lower the hydraulics, but it stays in the lower/raise position unless I manually move it back to center. This was my dad's tractor, I am more familiar with the lever on my New Holland TC33D which is not spring-loaded and just stays wherever you put it. Is the Kubota lever supposed to center on its own?
B7300 Hydraulic lever return to center?
- Thread starter Kubbie
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
B7300 doesn't have position control. So it's not proportional. You move the lever to "lift" and release it, and once the lift is nearly all the way up, the lever should spring back to neutral. If it doesn't return to neutral, there is an adjustment back on the right rear side of the tractor to adjust it.