GreenMtns
New member
Equipment
B2601, 4' Frontier Rotory Mower, 5' King Kutter Finish Mower, 4' King Kutter Rot
B2601 correct hydraulic pressure?
- Thread starter GreenMtns
- Start date
85Hokie
Moderator
Staff member
Lifetime Member
Equipment
BX-25D ,PTB. Under Armor, '90&'92-B7100HST's, '06 BX1850 FEL
Without looking it up .......I would "guess" closer to 2000, on the BX series, it comes factory around 1800 ish - bumping it to 2000 is about safe max.
What are you reading now? I did read that many are using a PSI closer to 2400-2500 after shimming.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
GreenMtns
New member
Equipment
B2601, 4' Frontier Rotory Mower, 5' King Kutter Finish Mower, 4' King Kutter Rot
Haven't checked it yet. waiting for the correct Male Fitting. I have read that it should be read from the loader lift line on the tractor. And of course, just to keep things confusing for us novices, others have said that it should only be done with a "T".
Which is correct?
Al
Which is correct?
Al
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Either will give you the same readings, it's just with the Tee you will have to max out the loader movement to get the reading.
Any chance you can take a picture of this in the service manual? Someone on Facebook is disputing this.
Gee, who to believe, they guy who works on them all the time (Wolfman) or some yahoo on Farcebook. Obvious answer to me. Maybe not to you however.
Though I appreciate sarcasm, I definitely don't appreciate being insulted. I know who to believe.
The proof was needed to settle a dispute. Turns out the other guy's proof was from a BX manual instead of a B. If I had a service manual then I would have settled it myself. I don't so I was requesting someone who does.
Sent from my XT1710-02 using Tapatalk