Greeting, I am a new Kubota owner recently relocated to 45 acres from 2 and bidding farewell to my John Deere.
I purchased a B1700 package that came with among other attachments, a LA302 FEL and front mount B2650 mid PTO snowblower. Currently the snowblower is setup to use only (1) hydraulic line that was factory/dealer plumbed to the front of the tractor with a quick connect to/operated by the 3-point control.
Ideal use case: I would like to put a back blade on the on the 3-point while independently operating the front mount snowblower from the FEL controls.
Question: Given the FEL frame/controls, can I remove the (1) factory short hydraulic line from the snowblower, add (2) 5-6' hydraulic lines in their place and run the blower off the the FEL control for up/down/float? This would free up the 3-point hydraulics for the back blade/other attachments.
Hope this makes sense, let me know if I can provide further info. Thanks in advance for your time!
Sent from my iPhone using Tapatalk
I purchased a B1700 package that came with among other attachments, a LA302 FEL and front mount B2650 mid PTO snowblower. Currently the snowblower is setup to use only (1) hydraulic line that was factory/dealer plumbed to the front of the tractor with a quick connect to/operated by the 3-point control.
Ideal use case: I would like to put a back blade on the on the 3-point while independently operating the front mount snowblower from the FEL controls.
Question: Given the FEL frame/controls, can I remove the (1) factory short hydraulic line from the snowblower, add (2) 5-6' hydraulic lines in their place and run the blower off the the FEL control for up/down/float? This would free up the 3-point hydraulics for the back blade/other attachments.
Hope this makes sense, let me know if I can provide further info. Thanks in advance for your time!
Sent from my iPhone using Tapatalk
Last edited: