Just purchased a M95s the RPM have to be up in the 2000 range or above to lift a 1000 pound round bale is this normal for these tractors or do I have a problem
Kubota M95 Hydraulic's no power at Idle
- Thread starter atvguns
- Start date
Mine doesn't need to, it can be idling and bring that much up. My grapple weight is more then 1000
But mine is a M9540
I'd say you have something going on. My L3000 will pick up round bales at just above low idle.
When was it service last?
What fluid and filters?
When was it service last?
What fluid and filters?
atvguns
Welcome to OTT
Have you checked hyd oil level & changed hyd filters? Changing hyd filters & checking hyd oil level is 1st thing I recommend doing. My M7040 will pick up a 1000# rd bale at engine idle speed.
Welcome to OTT
Have you checked hyd oil level & changed hyd filters? Changing hyd filters & checking hyd oil level is 1st thing I recommend doing. My M7040 will pick up a 1000# rd bale at engine idle speed.
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
Like Tx Jim said, have you done a full fluid and filter change?
If yes and you still have issues, then #1 get the WSM (aka Service manual) and #2 test the system pressure.
If yes and you still have issues, then #1 get the WSM (aka Service manual) and #2 test the system pressure.
Haven't done an M95S but have done quite a few M9540's and 8540's that have had a stuck valve in the position control valve assembly. Removal is required, find the stuck valve, free it and reinstall. Gotta lift the cab on the M-40 series to get access but it's not too bad.