Search results

What is the correct torque when putting injectors back in on a 245? thanks in advance

3 point linkage wont go up under load Filter is clean Good pressure from pump.Orings replaced in lift cylinder..What to do next? At the moment the 3 point will slowly rise with high revs without load

I recently bought this tractor The PTO is live and the lever that engages and disengages doesnt do anything. It goes from O to 180 degrees as if its disconnected if that makes sense Any ideas on whats involved to get this operating as it should?

Should this reservoir be filled to the top and with what sort of oil its a black plastic cap with oil written on it just below the alternator thanks in advance

My mower fired up then stopped. No fuel coming out of the injector pump but plenty coming out of the fuel filter.This has happened before and i fiddled around with the stop solenoid but dont think i really did anything and suddenly fuel spurted out of the pump..This time not so lucky..Any thoughts?

I Have lost my steering today.There were a few warning signs leading up. A few groans Some resistance at times to a hard turn.Any idea whats in front of me?

I had some major work done on the deck.There was major rust around the right pulley Ive just realised that the greasing point for pulley is no longer there which was a 50mm long tube coming out of the deck with a nipple on top. Is it as simple as picking a spot similar to the left pulley...

I need to replace the small spring which attaches to the foot plate and the foot throttle pedal and the local kubota dealership cant find any reference to it in the parts diagrams

1. How necessary is it to replace the filter screen rather than clean it? 2. Why is my transmission oil so dirty .I changed it 6 months ago and havent done many hours since

The 3 point likage arms wont go up under load.With no load they go up but only with full throttle. Ive changed the oil and cleaned the filter.Any ideas?

As per title pto cable drive belt cable not sure of correct description .Are they the same or different? i have to replace

Dropped bolt but cant see it .WAs taking out thermostat to check it and carelessly dropped the bolt. THe hosing does a bend and fished around with a bit of wire but no luck.Was thinking of getting a magnet to put down to the bend. Could it have entered the engine?It looks like you have to...

Temp gauge goes very high when engine isnt hot.Radiator blown out but not clogged. Changed the sender unit Any ideas?

Front right wheel is leaking oil where it swivels.Im presuming its the seal. I havent taken it apart yet but wondering how straight forward the job will be..Its definately not leaking where the 4 bolts are.

Is anyone else annoyed at the fuel filter set up on this tractor? I was blading some branches today and a stick must have hit the plastic cover.Not the first time ive had to replace it.Can it be replaced with a standard metal filter?

Can someone advise me what size socket i need to get to take the nut off the crankshaft pulley pref in mm

I did a fan belt today and an oil leak started...a big one behind the crankshaft pulley. There was some belt cord wrapped around the shaft. Im hoping someone has done this seal replacement and can give me a few pointers. Ive pulled out the radiator . what is my next move.It appears that there...

My 245dt had been sitting for 3 months and found the clutch stuck.Last resort i sprayed wd40 thru the inspection plate overnight now shes going..Just thought i would share the good news

Any tips on getting the radiator out on my g1800?It appears hard to get at

Hi Folks.My pto has an intermittant problem where the pto stops turning.Sometimes it stops after 5 secs other times it will turn it as it should.For example i was spraying yesterday and it took about 6 goes before it worked properly .Clutch plate perhaps?actually its a 245dt