Search results

Good news and happy ending to loader dumping slowly issue: I talked to a remarkable fellow at a local hydraulic shop who advised me to remove the back side of the valve, the portion where the spring enters and to check for crud and corrosion. Two 3/16 hex bolts hold it on. Full of crud. Cleaned...

7/8 = 22.225mm I used a 22mm wrench but they could be 7/8. I'll try getting 7/8 caps

22mm

does anybody know what size caps to buy? thanks

that's exactly what I'm saying

I didn't do the test labeled #2 because we determined that the machine had regen. Should I do test #2 ? Test #1 indicated what I think was good flow.

the loader boom lifts and drops fine the bucket curls fine just slow to dump

OK I disconnected the base end hose and I got what I believed to be good flow. The bucket still is slow to dump? I tested both cylinders. Same result. Any ideas thanks rob

Thanks Dan

My L45 is a 2011 model. As I said in a previous post I'm just learning hydraulic language. (just learned to spell it) When trying to determine if my machine had hydraulic regen, I searched online and found this definition: What is a regen on a hydraulic system? Regeneration is a general term...

Thanks Dan for your comment. I'll try your suggestion on Monday when I return to the farm. The loader on the L45 is the TL1000. There are no quick disconnects. It appears from the service manual that it does have regen. ( I had to look up what that meant) so I'll start with suggestion #1. When...

Hello all, My L45 front loader recently developed an issue where the bucket is very slow to dump. All other functions of the loader work properly. The oil is newer (about 150 hrs), full and clear. (Kubota oil). I know nothing of hydraulics but looks like I'm about to learn? I'm pretty mechanical...

Nice job. How's it working?

Pretty sure a 9540 will pull a 15ft. mower on level ground. Not sure about stopping at the bottom of a hill. Learning that 4x4 will help. Now I'm learning that new machines are in short supply, there is a 10% surcharge, and they won't be available till spring. Talked to a fishing buddy...

Thanks for your response. Do you pull a 15 ft. batwing with your M7040? How does your machine handle it? Do you operate on hilly terrain? Your post made me realize that my rear tires are are weighted so my machine is a little heavier.

Looked at the spec sheet for the BH2615L. With the chains, etc. it comes in a little over 5K lbs. My tractor with a Stoll front loader doesn't weigh much more than that, maybe 7.5K lbs. I'm sure the 9540 will spin the blades, my concern (and the seller's) is that the Kubota might get pushed...

Hello all. New owner of an older Kubota M9540. Tractor is in good condition with no known issues. This is the gear model, 8 speeds (4x4) with the regular shuttle (have to step on the clutch). I'm looking to match it up with a batwing mower to maintain about 70 acres of pasture fields. There is a...

Sounds like it was an accident that caused the problem. Maybe covered by insurance? Hope all turns out well.

Always good to hear of a happy ending. Always good when the original poster follows up with information to help the group. Thanks rob