Search results

I ran my tractor in 4 wheel drive on the road for about 5-10 minutes in high gear (HST) before I realized it. I was running at least 2650 rpm. Do you think I may have damaged anything?

MX5100 HST 4wd does hydraulic produce more pressure/power as engine rpm is increased? If yes about what speed in max pressure achieved? Medium duty use on a 2013 MX 4 cylinder , mowing/ a little bucket use , not excessive lifting. brush hogging a little post hole digging, tilling. 6 acre...

So i got a MX5100 with a bucket/FEL. I am needing to cut a little trench to drain off some water from a low spot i created digging out some dirt so my newly installed fence gate would swing clear. Its a 8' wide gate. Now I got a little pond right in front of the gate. The ground runs down...

2013 Mx5100 HST 4wd Have a little over 100 hours on it. Works well but 6 years old. Should I change the antifreeze? And can you point me to some instructions /tips? What is the correct antifreeze to use? Thanks

MX5100 4wd with FEL , Hydrostatic drive I in SE ohio , kind of a hilly area. I'll have a 6' mower on 3pt hitch Loader with some weight in it like stones etc So I put the tractor in 2wheel drive when I have to run on asphalt road. I'm in high range running close to PTO speed, pro disengaged of...

the brand of PHD and the auger any ideas?

I have a cat 2 3 point on my MX5100 I bought a used PHD. The lift eyes are 1-1/8" dia. on the lift arms. the pins on the digger are 7/8". i bought 2 bushings so the fit was tighter between the pins and arm. Is that prudent to due and or necessary? I seems like a good Idea to me so its more...

I have a MX5100 need to drill 50 holes for 6x6 posts. what size digger and auger diameter should i buy /rent? I'd mount on the 3 point hitch. any advice and tips appreciated

got the MX5100 stuck today

Changed out my Hydraulic filter. Have a steel type band wrench. Came off easily. Put it new one on, lubed the rubber seal , tightened it back up with the strap wrench. Fired up every thing seemed normal. Ran the tractor for about 1/2 hour Changed the engine oil and filter. when I went to drain...

Added KEN's hooks to bucket Used a chain to pull the old steel post with Concreate around it out of the ground.

The clutch pedal operated by your left foot. What is its function ,when to use it for what? The tractor is Hydrostatic drive.

Is there anywhere to download these in a PDF or whatever?

roughly whats the cost for the 50 hour service. oil for engine, oil filter for engine, hydraulic oil, 2 hydraulic filters, fuel filter, oil for front axle. Did I miss anything? cost of materials? do you guys use all Kubota filters for everything? what about the hydraulic oil and front axle...

I'm going to be taking down a 2 story farm house built in 1910. putting old walls, blocks/brick etc in a dumpster. i have a FEL on the MX5100. What would be a good choice for a bucket for this task? What would be a ballpark cost also?

Hello all. will soon be taking delivery on a 2013 MX5100 with 30 hours on it. It has the front end loader, 6'brush hog,6'finish mower, a box scraper and a blade. I purchased a small pc of land that was part of an old 40 acre farm. I only have 5.5 acres which about 3 acres of that are a pasture...