Search results

I would like to flip the tires on the rear of my L3901 to get a bit wider stance. From what I have seen I just remove the tire on both sides and flip them to the other side to gain about 7 inches in width....problem these tires are heavy to begin with and these have fluid in them. Any tricks...

I was using tractor last evening and all was good. Hoped back on to start it up....dash worked as it should but nothing on ignition. I have had the pro switch cause this before so jiggled it...nothing. I tried the seat switch and still nothing. Then I noticed the code on dash OPC which I...

I was using my tractor last evening and I turned it off to do some work. When I tried to start it again...it would not start and had OPC in the hour reader....I have had this happen before with the PTO level needing to be jiggled and it would start....this time it was the HST pedal. The tractor...

So one of my Nigerian Dwarf goats thought he could drive the tractor!

I have a TSC 6ft blade on my L3901. The nut must have worked loose over the years and has stripped the threads so it can't be tightened...it just vibrates and is causing the hole in it is mounted in to wear. Any ideas on how I can get this old pin out and replace it with a new so I can tighten...

I was doing my 100 hour service and went to start the tractor and it would not start....the dash showed "Open" (I think). Anyway after messing around I happened to jiggle the PTO lever which was already in the Off position and the word on the dash went away and I could start the tractor...if I...

I have an L3901 2 years old with just over 60 hours. Is it worth the money to extend the warranty? How much should it cost? Who has done this and have you used it?

I was brush mowing on my L3901 HST yesterday and finished or so I thought. I pushed the clutch in and turned the PTO off and let clutch out only to find it did not disengage. Had to just turn it off to get it to stop. Made a loud clang on the brush mower. Learned I could hold the clutch in and...

Does anyone know what size post on a ball hitch I need to fit the hole in the draw bar on my L3901? I would rather not make multiple trips because I got the wrong size....hoping to pick one up on my way home, as I have been out of town and forgot to measure before leaving. This is needed to...

I want to widen my rear R1's on my L3901. I know that you pull the tire off flip it around and the roll it to the otherwise and remount it. My question is what nuts am I suppose to pull to do this? Is it the 4 nuts that hold on to what looks like a z shaped bracket? Pictures would be great if...

Hey Kubota Guys I want to pull a small trailer for hay rack ride. I have an L3901 HST. Can I just put a ball on the tow bar that sticks out from rear of tractor and attach safety chain or do I need to do something different. Thanks

Does anyone know the top speed or even the speed range of the L3901 HST in Low range? I am hoping to spray some weeds soon and want to have an idea of setting sprayer pressure and flow rate for specific speed. Thanks

I am looking for a good 3 point sprayer for my tractor. I don't want to spend tons of cash but also don't want to buy crap either. Any suggestions of good products? Thanks.