Search results

My friends M9540 won't start. He has cleaned/tightened all battery cable ends. Battery tests 12.5 volts with wire loose from starter solenoid post but volts lower to 6.5 when wiring harness supply wire is attached to large starter solenoid post. Anyone know where can he get a copy of the wiring...

My neighbor asked me what his '14 MX4700 2WD(400 hrs)with standard trans,LA844 FEL with bucket,LandPride RCF 2072 that he purchased new was worth? Anyone have any idea of value? Thanks,Jim

AC was cooling fine yesterday & early this AM. I blew out exterior of radiator & condenser with an "air comb". Not much dust or chaff blew out. Cleaned both cab filters. Checked to be sure AC comp belt is snug. Installed AC gauges,pressures were 52# & 300#. I think orifice must be clogged. This...

Due to the fact that I own a larger JD tractor that I utilize Hy-gard hyd oil in it I'm thinking about changing my Kubota M7040 HDC over to utilizing Hy-Gard so when changing to different equipment hyd oils won't be intermingled between tractors/equip. Any thoughts about my idea? Thanks,Jim

Yesterday I was handling some rd bales with my tractor with 1591 hrs & noticed after I moved a few bales the boom would get slower going down then it would return to normal speed. If I moved joystick to float position the boom always lowered much faster. Movement of joystick feels the same as it...

My '11 M7040 with 1500 hrs on tach died when my daughter backed it out of barn. I've cleaned the water separater filter,installed new fuel filter,made sure tank was FULL of fuel,blown compressed air from water filter to tank. Engine will start & run a few seconds then die. Next time I attempt to...

My neighbor asked me what to do to get hyd pump back to pumping after changing hyd filter. I told him only thing I could think of is with engine idling put short bursts of low pressure compressed air in hyd filler hole with opening blocked off with shop towel which hopefully would prime hyd...

Is there an adjustment to make detent on scv easier to release on my M7040? I have my JD 467 rd baler attached to my Kubota tractor & the scv detent is very strong. I looked in WSM but didn't locate an answer. My M7040 pulls my 467 very well making 4X5.5 bales. Can I change detent pressure by...

Anyone had their emergency/turn signal lights stop operating but fuse tested GOOD? I heard a loud click after one flash then no lights. Flasher is $78 so I'm not wanting to buy unless necessary. I know I can check flasher supply wire for voltage but I must remove dash to access the wire. Thanks Jim

Does a B2920 with a FEL have a 3 pt hitch relief valve in rockshaft housing? Thanks,Jim

Has anyone tried installing larger frt tires on a M7040 MFWD(9.5 x 24 vs 11.2 X 24) for better handling of rd bales of hay? Rolling circumference of 9.5 is 123 & RC of 11.2 is 129. Thanks,Jim

Here's a photo of my M7040 baling Wheat straw with my JD 347 baler. A 30 ft combine header makes for a BIG windrow and sq bales close together!!!