Search results

I'm coming up on my 400 hour service and am wondering if there are any uses for the used hydraulic fluid other than just taking it to the recycle center,

Every now and then my lx2610 jumps out of medium range when travelling. It happens mostly when I'm not putting a hard strain on the transmission. I've got about 345 hours on it and has done this for a while now. Not sure if there is an adjustment that I can make.

I'm starting to research 3rd function and grapple for my lx2610 and have questions for the group. I'm going to start with either Kubota or Landpride 3rd function kits being installed by my dealer and am going to look at the SCG06 series grapples. My main use for the grapple will be for cleaning...

On days like yesterday and today when all I can do with my Kubotas is think about what I want to do, I get out the lathe and play.

I just bought a new zero turn and I need to keep the chute in the raised position to go through some areas especially around the raised bed gardens. I had a neighbor tell me yesterday that he took the chute off of his mower and just left if off. Is there any reason that I couldn't or shouldn't...

Please forgive my lack of electrical knowledge, but I have this pocket multimeter and am wondering if it is able to check the battery on my lx. For the totally unitiated it does not appear yo have a 12 volt test setting. If it can be used where would I set the pointer to?

I believe I've read somewhere here that one of the members sells hydraulic toplinks. I'm interested in one for my lx2610. Any info would be appreciated. Thanks

The 200 hr service on my lx2610hdc only calls for changing the engine oil filter and transmission oil filter and not the hydraulic filter. Just curious why not changing all of them like at the 50 hr service.

I have some unopened bottles of 85 to 140w gear oil. Would it be OK to use that in my snowblower that calls for 80 to 90w? It says it's good for severe Temps. Not trying to stir @#$%, just asking for my own knowledge. Thanks.

The nozzle for my rear window washer broke where it goes through the glass and when I went to replace it I found that it was hitting the cover for the cab inlet filter when the window was fully opened. I notched the housing to allow room for the nozzle and the problem is gone. Posting this as a...

I'm looking for some advice on how to set up my tractor to move some material tomorrow. I have an LX2610 Cab model with loaded R14s and I currently have a RB1684 rear blade on it. I'm receiving a Woodland Mills WC-68 which the shipping company has listed at 825 lbs and will drop off at the end...

Now that I got your attention I have a serious question. Is there a rule of thumb for what side angle to not exceed to avoid tip overs? In the manual for my lx2610, it basically said that if you are not comfortable, don't do it. I seem to remember seeing someplace that 20 deg is the magic...

I have a heavy hitch tooth bar on order and am wondering if I can leave it on the bucket when I take the FEL off to install the snowblower in the fall. Not sure if the tooth bar can take the stress of lifting the front end to release the pins.

Being new to tractors, when I bought my LX2610 I didn't think to ask the dealer for a WSM. I've looked online at kubota books and other places and have not found one out there. Anyone know if there is one available on the free sites yet?

Does landpride make a stump bucket that attaches to a PFL1242 pallet fork?

I've searched and have not been able to find anything on the landpride wood chippers here. Any comments good or bad on the 1504 chipper?