Search results

I have a few of them. Ill send you a message

Undo the carrier bearing and the shaft should slide off the output shaft of the transmission. But ive taken many transmissions out and they are all rusted on there. Nothing holding the coupler on there besides rust. Penetrating oil will help but its just a pain. And no good way to get leverage...

If you can find a shop to repair thats probably the cheapest option. But id have radiator and fan here if you need one.

In each end of the front axle case there are 2 orings (3 and 20 on diagram) and a bushing in between them (2 on diagram). You may or may not need to replace the bushings depending on how much wear there is on them and the pin. Bad part is you have to drop the frame to get the pin out. If your...

Most common cause is pto shafts get shoved up into the housing. Pto shafts too long is most common but have heard other reasons like one of the lower arm pins came out and disconnected from the implement.

Thank you sir

Pretty sure i have a good one. Ill send you a message

Haven't had anyone ask me that question before. Small bore and short stroke so really won't make much difference but down there will be little to no fluid in the cylinder. Head bolts are fine to reuse as long as they are in good shape.

Where did you get the new lift pump? If its a china special off amazon they are hit and miss and may very likely got a bad one.

I have a few of them in northeast Alabama.

Thank you sir

Rear would be fine. Fronts however on the b2150 use the old style 6 bolt rim and 3300 uses new style 6 bolt rim. Bolt pattern is slightly different. And as others have said the fronts are smaller diameter on the 2150 so ratio would not be correct

Most likely a safety switch. Seat is common. But also make sure pto is disengaged. While holding key in start position wiggle pto lever and gear selection lever and hydro pedal see if anything changes

That's no good. I have parts here when yoi figure out what you need. Your also welcome to send me a message with your phone number. Happy to answer questions

B7200 was made from 83-90. Tractor years are based on when they were sold not when they were made. So one made in 1990 but sold in 1992 would be a 92 model. Many models would have and old and a new version. It just means in the middle of the model run they made some changes. For the most part...

I appreciate that. Its always my goal to help people fix their tractors primarily and sell parts secondary. What people do with my information is up to them. But anyway let me check i may very well have a good shaft ball nut assembly

Watch the youtube videos then ill add this. 2 cylinders with pistons in them. The pump cylinder does nothing while in neutral. When you push the pedal forward or reverse the swashplate moves one direction or the other (forward or reverse) thus pushing the pistons in. This now is creating...

Like @D2Cat said check the valve on the hydraulic block down by your foot. Closed the 3 point should work but not loader. Open they both should work as your feeding the loader and then the loader is feeding thr 3 point but sometimes a middle position can cause problems. Also when checking make...

Thank you sir

I do have a couple good steering boxes for b7100 gear drive. It is unfortunate they cannot seem to get these aftermarket steering gearboxes right. There is a good market for them. But i get lots of people try them because they are cheaper than a used oem box only for them to come back and get...