Search results

Moved the chicken coop I'm building so I can get the holiday trailer on the pad.

The only cons with the pats is top link and pto shaft may be too short. I have them on my B2601 and will run them again if I get a different tractor.

For the front tires on my B2601, I got tire chains for a atv, there and 23" tall tires. Haven't broke any links or anything, I'm not nice to my B2601. The rear tire chains are for a skidsteer and I got them used. Both sets for under $200.

The fact the B 2601 has skid steer tires on the back, skid steer tire chains fit with out wheel spacers.

I have a B2601, and it has the 60" bucket. I wouldn't go any smaller. I've moved lots of dirt, sand, gravel, wood chips, and snow.

I got a bunch of shims from my Kubota dealer, they where under $3.00.

I run Pat's on my B2601, the top link still works for everything I run on the 3PH.

My wood chipper with 2 saws and some tools is over 800lbs and my B2601 3 point lifts it no problem.

I run my Woodland Mills WC68 on my B2601, there is a in-feed speed control. If you ran it your bx you'd have to slow it down more, and not run to large of wood though it. Blade sharpness does make a difference in how the chipper preform too. The other thing is the WC68 is over 700lbs too, that...

My B2601 hit 132hrs so I changed the fuel filter, and installed my 3rd function kit(it came in a 5 gal pail and had no instructions from Kubota).

My dealership sends all there Kubotas out with a 60/40 mix, pretty much everything I own that needs coolant is 60/40 we do see -50'c.

I live in Northern Alberta Canada, a few days ago I had to plow snow. I don't run a cab on my B2601, but it does get parked inside a heated garage. I was -33'c outside, 10'c warm from the days before. On my B2601 I do block off the rad with some cardboard to help with keeping the engine temp up...

It was over 15% more when these machines are in the 50 to 60 fpt range 8 more Is quite a bit. "Horse power sells car, torque wins races"

The B2601 has more torque then the BX, my dealer I delt with had motor and pto hp and torque numbers they got with there dyno.

I'd go with the B2601, it can lift more little bigger tractor over all. The B2601 has more pto hp then the BX.

I use one of these on my 20l fuel cans for my B2601, helps to stop spills.

I know what your saying. On my B2601 there is the orange pto 540 speed marker on the tach. Before I changed the factory oil(most likely break-in oil) the tach would not go past the orange bar. After the oil change it will sit just under 3000 rpm. Oil does play a part in how a motor will run ie(I...

I was doing hours of loader work, and I just happen to grap one when I was off the tractor. Like I said I wasn't worried, I just noticed a difference in temp with the side panels off. I got my woodchipper is a few days ago, and running that for 3 hours straight, the temp gauge was not even at...

My B2601 has 70hrs so far, everything is good on it. When I was moving dirt it was wet heavy clay, and was taking heaping buckets maxing the hydraulics and the ground is fairly soft(this job should be done with a skid steer with tracks).The other thing I wasn't worried about the temp, when I...

I make sure the rad screen and rad clean all the time.