Recent content by tjaltz

Thank you.

Thank you Sir.

The toggle is mounted on the loader joystick to control the electric solenoid on the WR Long 3rd function. Press it one way the grapple opens, press the other way the grapple closes. I know which hose on the 3rd function connectors is the pressure side. My question is, when I connect it to the...

My third function and implement quick connectors are all male/female, so they can only be connected one way, so they are always connected the same. I was more concerned about what would happen with the flow control if I press the return side of the 3rd function switch instead pressure side. I...

I purchased a Samurai Sickle Bar Cutter for use on my B3200 (6.7 gpm) and my L6060 (9.4 gpm). I will be using 3/8 hose from the 3rd function quick connectors to the Samurai Cutter. The manufacturer felt that the pressure/flow on the B3200 would be fine for the cutter at a fair RPM to achieved...

If you have PB Adapter that would be great. I was going to call Summit later today to find out when they were expected. Thank you.

Dan; You have been incredibly patient with me and I appreciate it. I do have one more question. I am piping it together as you suggested, shown in (yet another) flow chart below. I just got a notice that the Power Beyond Adapter from Summit for the P40G-2A1 valve body is on back order. I need to...

Dan, I removed what was necessary to access the loader valve tank return hose. I probably have a little more room on the bottom to insert a tee than I do on the top. It’s a relatively soft hose compared to the high pressure lines, and is just held on with hose clamps. Is this because even though...

Thank you Dan. I will take the seat/suspension off to get a better look at the tank return hose, then go back and create a revised flow chart, which at this point has become therapeutic for me.

I think this is what you’re suggesting. I‘m don‘t really understand the difference between the separate Power Beyond port created with the adapter in the N port, and the pressurized tank return line from the Summit Valve. Since I have to remove the 3 Point to mount the backhoe, I would never use...

Thank you sir, I think I understand. It shouldn’t take too much for me to adjust the flow correctly. I will just need to replace the banjo fitting and pipe that faces rearward for the backhoe with something that I can connect to the WR Long “P” input. Does this new flow look correct to you.

Dan It's a Kubota BH-76 Backhoe. Originally the PB circuit was used only for the backhoe, and was usually just connected with the hose loop, as the backhoe is not normally mounted. When the dealer installed the WR Long 3rd function, they fed the 3rd function's P port with the backhoe outlet of...

Sorry, it may be because I'm looking on a mobile device, but I cant see your response.

I have a B3200 with a power beyond port installed for a backhoe. I recently had a WR Long 3rd Function installed by my dealer. Now I’m adding (on my own) a two spool manual control valve for rear remotes. I have the piping laid out and just want to make sure there is no problem with my design...

I have a well maintained B3200 with 300 hours on it. It has hydrostatic drive with three ranges. I recently added a 50 inch Bush Hog tiller that has a PTO shaft with a slip clutch. I made sure to slip the PTO shaft clutch by following the directions to loosen the bolts, turn it on and make sure...