Shawn T. W's latest activity
-
There appears to be a legit tractor dealer at the 1445 Main St address listed on the web page associated with the link you posted, but... -
Shawn T. W replied to the thread Is this to good to be true?.Neither Case Construction Equipment, nor Case IH Tractor shows a dealer there, Woodbury is near the center where the target is ...
-
-
Shawn T. W replied to the thread Is this to good to be true?.That L5740 is less than I just paid for my older, smaller with more than 4 times the hours L5030, and mine doesn't have a loader or BH...
-
-
-
Shawn T. W replied to the thread Considering a L5030 HSTC.Unfortunately lots of idiots on the road today! These are my videos, I personally experienced! Note this is a very wide angle lense...
-
-
Here's a screen shot of the brick and mortar on google earth. If it weren't 200+ miles one way I'd drive over and take a look. Looks...
-
Obviously legit since you found it on goggle and fakebook. Email photos of all your ID, credit and bank cards along with PIN. The...
-
I designed and built a log arch to keep them clean for sawing. Let's a small tractor move larger logs.
-
Shawn T. W replied to the thread Considering a L5030 HSTC.53' dry box ...
-
Shawn T. W replied to the thread Is this to good to be true?.Can't be a serious offer ... Don't cash in you 401K. But if you have time, ask them when you can come by and see it ... Get the serial...
-
Shawn T. W replied to the thread Offsetting rear blade ... should I grease it?.Just be aware the farther you have it off-set, the more weight on the back of the tractor you will want, if your doing more than a light...
-
-
Shawn T. W reacted to matt-m's post in the thread What did you do to or on your Kubota today? with
Like.
I filled mine with concrete and have no regrets. Since you are welding capable here's a few ideas to share. The dolly has been super handy. -
Shawn T. W reacted to NCL4701's post in the thread What did you do to or on your Kubota today? with Like.
Had a tree in the pond. Not a big one. Needed to come out. A bit of a PITA because it was about 90% rotten the first 12’ or so and split...
-
Hubbed bucket bushings drilled & reamed for cross hole, and all (4) installed with interference fit.
