Shawn T. W's latest activity
-
I need a lot trenching (150-175ft) at my place up north- very hard & rocky ground. It is certainly not a commercial level machine, but... -
Shawn T. W reacted to Hoserman's post in the thread What tools/wrenches to do basic maintenance/servicing on L3902? with
Like.
Yep, if you can't fix it with a hammer, it was probably broken to begin with. :LOL:😜 -
Shawn T. W replied to the thread Blade/Box for L345DT with L1720 FEL.I'd say a 6' box and 7' blade might just be the most, but probably less ... I pull a 5' land plane, and a 6' rear blade with my 25 HP...
-
Shawn T. W replied to the thread What did you do to or on your Kubota today?.I would not fill it up all the way ... I built my own, and left a lip on three sides, great for holding things like small tools ... I...
-
-
Shawn T. W reacted to nerwin's post in the thread What did you do to or on your Kubota today? with Like.
Painted the receiver tube on the ballest box, now it almost looks factory! Most importantly, it works perfect! This is...
-
Shawn T. W reacted to dirtydeed's post in the thread What did you do to or on your Kubota today? with Like.
I'd say that the weeds were between 1 - 3 ft. Depending on location (stilt grass was pretty tall). The cutting height was probably...
-
Shawn T. W replied to the thread What did you do to or on your Kubota today?.Why I asked was I'm considering a flail, but I don't want to cut that low, prefer about 5" ... I've read quite a bit about them, and...
-
Shawn T. W reacted to dirtydeed's post in the thread What did you do to or on your Kubota today? with Like.
I really couldn't say. It's not my property. There have been many times where I had to gain access to the pasture where no gate exists...
-
Shawn T. W replied to the thread What did you do to or on your Kubota today?.Curious how high the weeds were before you cut them, and high you left them after cutting? (What's your cutting height?)
-
Shawn T. W replied to the thread Considering a L5030 HSTC.Yup, gone for a few weeks at time, unless I get a load which happens to go by home ... This is my "little blue house!" 😂 Parked at...
-
-
Shawn T. W replied to the thread Considering a L5030 HSTC.This probably the worst of the "Rocky pasture" ... Occasional I'll hit one just right to drag it up out of the ground, I then stop...
-
-
Shawn T. W reacted to Bmyers's post in the thread What did you do to or on your Kubota today? with Like.
I did some mowing, but had to stop and eat some black berries. Guess I should of taken the picture before I had eaten most of ripe...
-
If he would’ve just kept driving he would’ve been fine, lol. But yes that trailer is very similar to what I currently use to transport...
-
Yes, the rod will just rest on the cylinder wall. Push the lift arms down to move the piston to the highest position, then I used a...
-
Thanks. They have gotten a bit of bad press IMO, but I have not been at this hobby so long to be stubborn just yet. The tubes and...
