Recent content by JD55

My F series had a loose fuel line, clamp was not tight on fuel filter, replaced and stalling went away.

I had a loose clamp on the fuel filter that periodically allowed air into the fuel line replaced the clamps and everything is good. check and see that the fuel filter is full of fuel.

Mine did the same thing, it was a pin in the injection pump, It was rebuilt, then did it again. Different pin. Plus, make sure they shim them correctly,and check all three.

OK, now I am looking at a 2017 U35-4 with 49.5 hours for 42,000 available for 0 down 0% for four years. Remainder of warranty and like new from rental stock at another local dealer. Cab unit, so I am leaning this way now; does that sound fair.

Okay, first of all thanks for all the replies. Have done a little research and have found a couple of 2017's . A cab model for 48,000 with a 0 down 4.5% over 48 to 60 months, and a open cab for 40,000 0 for 48 months or 60 months at .99%, obviously much better looking deals to me. If I swing...

I am looking at a used U-35 serial no. 2024, with 5,000 hours on it. The tracks have been replaced recently. And the pump is new. I am not sure of the year. Asking price is 28,000. General appearance is good. Everything functions tightly and it has a hydraulic thumb. Anything I should be looking...

I have had my M5140 for two years;I just looked it has 1400 hours on her.

I grease all my fittings each evening the hoe is used before I put her to bed. I mean hers.

http://alpinecutter.com/en/products/rockwheel.html You might want to look at this page, a friend of mine use to work for this company. He repaired and serviced these cutters all over the world. He is now in Wyoming excavating caverns under old oilfields, creating reservoirs for the collection...

Okay, here's the thing, in a perfect world I more than likely would have gone with a three way blade 8 foot long, and added the third remote. But this blade came up and it friggin looks like new, and was only 2500 dollars, so I told the guy to bring it over and I would try it for a couple days...

Thank you, I thought I would be and you were correct. thanks for your reply and I will be thinking about the gauge wheel. After these rains I am sure I will be getting to use it again. Had to switch to the backhoe and dig up and replace a curb stop yesterday. No it's time to ut the blade back...

Hello, Wanted anybody to comment. After twenty years of operating a ford 2610, and after observing discussions and talking with my regular dealership and equipment supplier. (They just switched to Kubota.) I purchased a left over M5140 shuttle shift tractor. I maintain about 2 miles of stone...