Recent content by Jb35401

  1. Jb35401

    Speedometer stopped working

    7040sud 4wd
  2. Jb35401

    Speedometer stopped working

    I believe its the su version. Where will that info be found
  3. Jb35401

    Speedometer stopped working

    Where do I look for the sensor/cable or is that the likely problem. Display shows 0
  4. Jb35401

    1153 fel grease fitting size

    Bought an assortment of metric and standard. The threads are not 1/4 28 by a long shot. Metric m10 is close but too big. Anybody know exactly what size it requires. Its at the pivot point at the end of the tilt cylinder
  5. Jb35401

    Removing rear guard on 1860 landpride cutter

    Its about 1.5 inches higher at the back vs the front. I removed the guard yesterday and it cuts much better in thick grass than with the guard. The next step is maybe a spare set of blades. One sharpened like a mower blade and one for bushes
  6. Jb35401

    Removing rear guard on 1860 landpride cutter

    Been toying with removing the bolt on rear guard on my 1860 cutter. I have several acres of bahia grass to cut and it bogs down the tractor. Thoughts?
  7. Jb35401

    Grease fittings

    What sizes are on the fel and tractor. Im assuming all are metric.
  8. Jb35401

    How to remove m7040 hood

    Thanks! couldnt tell trying to look from the front and FEL is blocking view also. I was trying to figure a way to remove the hinges. This is much easier.
  9. Jb35401

    How to remove m7040 hood

    Rats have chewed into something and tractor won't even illuminate the dash lights or anything else. Huge nest at end of engine against firewall. Cant access anything with hood in the way. I can disconnect the gas shock but that doesnt help. Hood must come off to access damage to fuel hoses and...
  10. Jb35401

    Rotary cutter recommendation

    I bought a landpride 1860 from a local dealer in Mississippi. So far no negatives
  11. Jb35401

    7’ Back Blade on a L4760

    Depends on weight. I use a tufline gb5 7 foot blade and a 7040 pulls it fine. Its about 1200 pounds best i remember. But it will cut hard ground. A lightweight grader blade would be fine. Wish i had bought an 8 footer to maintain 7 foot width while angled
  12. Jb35401

    Bumper for l3400

    Looks good . Any guess on the weight?
  13. Jb35401

    Bumper for l3400

    Front end is too light. Been thinking about a 5 inch solid steel rod for protection and weight. However, i dont want so much weight it will prematurely wear the front end. Any pictures of custom bumpers or suggestions. I really dont want to use tractor weights