Recent content by beetlebaily

Here it was a fuse that did dash lights AND ignition switch:)

My son started it no problem, backed out of garage forgot something so shut it off. Got back on and would not start no dash lights no cranking nothing. Checked battery fully charged and has fuel. Any ideas??

Thanks, lots of jiggling the hydraulics and prying on back of loader arm put finally got it back in. Decided that I will never remove them complely again. If grease fittings wont take grease in the future, I will just slightly tap them back and forth but not take them clear out. PHEW!

about 1/8 " or less off. Tried playing with the hydraulics but still off. I'll try to get another person and breaker bar.

Hi, my B7800 has a LA402 front loader. The top two pins closest to the driver would not take grease. I replaced the fittings and still no luck. However the new fittings worked in other places, so they must not have been the problem. I took out the pin and the loader shifted a tad. I cleaned...

Had a rear tire go flat on my 300 hr B7800. Repair guy removed tire and showed me the pitted and corroded rim. He blamed it in the calcium/water mix and Kubota's poorly made rims. He then installed a tube and refilled it with the mix, saying the rim would eventually puncture the tube. Owners...

I have a B7800 and would like to hook up some type of box for carrying chains, chain saw, etc. Any ideas where to put one??

I have a B7800 and am trying to figure out where I could attach some sort of tool box big enough for carrying chain and chainsaw, etc. Anybody have any ideasA?

No, the 3 pt hitch cannot be used after you attach the hoe.

Yes, you should lower all hoes loaders stabilizers, etc when not using to relieve pressure on hydraulic lines.

I have a Woods DH70X backhoe that came with a used Kubota B7800 I just bought. I really don't need it. Cost new in 2007 was $7500. Asking $5,900. The tractor only had 80 hrs on it and the owner said he rarely used the hoe. I have not used it at all. Located in SW PA.

Thanks for the suggestions. We looked under the tractor and found a piece of branch that was pinching the hose against the frame. Removed it and problem solved. Wierd how stuff happens

there is one line and I hooked it to the back of the tractor to the only quick connect port I saw

It runs off the main hydraulic from the tractor. The fluid is ok. The arms are down and wont come up

Hi, I just purchased a used B7800 with 80 hrs. The front loader and backhoe were working fine. I took off the backhoe which runs off the main hydraulic line, put the 3 pt hitch on and attached a mower. Now the loader works slow and I can't get the hitch to operate. The arms are down and wont...