Recent content by 555

Hello I used a 3x 8 x 1.25 inch stoke cylinder , it was used. It has lots of power maybe to much but just make sure you build your anchor point on your frame strong. If you buy one at an auction sometimes they leak and you would have to put new seals in them, but sometimes cheaper than new...

Yes, I posted pics also thks

Hello all just a follow up to my May 20 2023 post on my Grapple I made. As you can see in the pics I put serrated teeth at the end of the grapple thinking it would grab the wood better and hold it. Well it did grab it to well and broke my mount on the stationary end of the cylinder. The...

Your idea is exactly how I did mine

That's just a short piece 2" of C channel cut out with zip cut

Thanks yours is similar to the way I did mine

I did weigh individual pieces and I'm thinking its a little more than the bucket not including the Hyd. cylinder. Its fitted to a B2601 so I will watch what I lift thks

Finally all painted - done. Decided to my a grapple and save some heavy lifting. Had no plan, just added to the quick attach frame I had made for a set of forks. Just have to slide the forks off and attach the lower prongs, attach the grab hook part with hydraulic cylinder. Hooked it up to...

Sorry to hear about your injury's hope you get back to good health. Don't look back you guys will love your Kubota. Life is crazy these days, but things will get better for you. Congrats.

Hello if its any help I just finished putting a Kubota 3rd function on my B2601. When I tested it it immediately blew the fuse. I checked the fuse box up beside the motor and found Kubota put a 5 amp fuse in, so I checked the service manual and it says "up to 35amp Max. Changed to 10 amp. ok...

I should have clarified that I put a 10 amp fuse in place of the 5 amp to start with. I will see if it is heavy enough once I get my homemade grapple hooked up. THKS

Hi I just put a Kubota third function valve on my B2601, it went good. But when I tested the switch I heard a klick from the 3rd function valve. Upon investigation, Kubota had put a 5 amp fuse in for the accessory wire which is not much good for anything. According to the service manual it...

Hello, just did the same thing, I put a bead of black silicone on the ROP then press your wire loom into it and hold in place with tape, clamps etc whatever holds it there till it dries

No this model does not come with a cab but if you look in the fabrication section you can see the cab I built, I think I posted it last Sept,Oct around there

Hello I posted this pic and there is a short 3/8" circulating hose from fan housing to thermostat so I don't think I can completely stop the flow. My heater hooks up to line from fan housing and runs through heater and back to thermostat in a loop. Because I can't restrict the flow of the...