Recent content by 1970cs

Pull the hose after filter and do a gravity drain and see if the stream is consistent. If not, I would assume you have something in the tank. If not suspect the fuel pump or possible air leak. And yet another thought. Is to first try to see if it's a fuel cap issue. Remove cap when the issues...

Also you need to check, the O.D. of the rear tires. The supplier has been known for supplying tires one bigger than the other. Pat

Your information is not accurate! The Kubota insurance is added to each and every payment. Unless it was a farm account that was setup for annual payment? If the previous owner paid off the last year in full, then Kubota credit would have gave a 10 day payoff less the insurance. If the previous...

Engine serial number break! Pat

Nothing sketchy at all. Same thing in life, you mess up and you pay for your mistakes. Ask my ex-wife!:rolleyes: Pat

Have you called your local dealer? Is your tractor still financed with Kubota? Pat

That's a stop for your ROPS. That is just a touch job. Non beauty part. Grab a can of Kubota gray. Pat

Pictures? Yes, if it's small then mostly a touch up job. If it's considered a major problem, we would just get it done at a qualified body shop and use their invoice for warranty purposes. This means it still goes through your dealer. Pat

Ok lower it till it's just above stall! You will have to experiment with the RPM's The shear bolts don't take kindly to harsh engagements. The electro/hydaulic engagements are usually all or nothing. Or very little modulation/feather/cushioned start up. Pat

Go to about half throttle. The driveline/PTO shaft is it a shear bolt or slip clutch? Pat

IIRC that the 6 year powertrain warranty did not start until July of 2016. You should fall under the 2 year full and 3rd year powertrain only. You should have been handed a small booklet 3" wide by 8" tall with Kubota warranty hand book orange/white color. Pat

First question, can you make it pay for itself? Good avg is $1200.00 per/foot of digging depth. Installed with a subframe. Pat

Both applications can be pre-approved from Kubota. It's actually much easier just to take it to the dealer for approval. The reasoning for it, that each piece being purchased counts towards the decision for funding. Pat

It's possible, my speculation is no! That deck is meant for a BX1500. Which has a shorter length compared to 1800 or 2200 which were 16" longer. Pat

I would try cleaning your ground cable connections on both ends. Pat