Toolbox ideas for L4060HST-C

[Ridelght]

Been toying with 3 inch od pvc pipe and cap to utilize this space for nylon straps and small hand tools.
opening is 3.5 inch, looking for test plugs online to make it even easier to open up.
just a thought. I put o rings on because mine is not completely round and it snigs it up nice for now
View attachment 78074 View attachment 78075

Wound up trying a few rubber stops. Didnt work. Painted these, they dontbsticknout past any other part of loader.

 

[jyoutz]

I did similar to above for my MX. Had an old Stanley tool box lying around and drilled out holes in the bottom to match where the OEM box was. Added a couple washers and reused the OEM bolts. Lots more storage and literally free.

View attachment 78543

I added a piece of flat steel to extend the SMV sign out behind the toolbox.