My three point lever is so loose it just falls to bottom. How do you tighten it so it can properly be used. Thanks. Its on my L2202DT
Three point lever
- Thread starter jims2202
- Start date
North Idaho Wolfman
Moderator
Staff member
Lifetime Member
Equipment
L3450DT-GST, Woods FEL, B7100 HSD, FEL, 60" SB, 743 Bobcat with V2203, and more
There is 2 nuts on the shaft that adjusts that.
Take some pictures of your linkage and I'll point out the right ones.
Take some pictures of your linkage and I'll point out the right ones.