Sinking

[Gr3528nas]

I'm working on a ku ota 722d, it's in a bobcat toolcat 2300, I seen it run then it hot water in the piston from the breather, so it bent a rod. I pulled all the rods replace all of them and getting ready to torque the head tomorrow. My question is the timing, shouldn't I have to put this back in time? This is my first mechanic work. I dont have the manuel. I've downloaded the pdf file. Any help is greatly appreciated.
Greg

 

[lugbolt]

no timing necessary unless u removed the injection pump or the gearcase gears

just removing the head and pistons, no timing required just reassemble it & don't forget to adjust the valve clearance

 

[Gr3528nas]

no timing necessary unless u removed the injection pump or the gearcase gears

just removing the head and pistons, no timing required just reassemble it & don't forget to adjust the valve clearance

Well I did remove the injection pump. Manuelslib.com is the pdf file I downloaded is that fine. That were I'm going to be getting most of my info for timing and to check valve clearance, thank you in advance