Removing "trim" on bx23s

[Kmcmjmtm]

I'm adding rops lights to my new bx23s and I want to mount the switch to the "fender control plastic trim"???. Haven't decided which side yet, but I'm not sure how to remove the trim to run wiring and mount switch. The tractor is brand new and I hesitate to start prying on things cuz I have a tendency to break things...especially trim fasteners and the like. Any help is greatly appreciated. Thanks

 

[lugbolt]

On the older BX's (BX24/25), there were some bolts under the fender that held the trim down. One of them held the handle to the fender. That one can get stuck.

 

[John T]

Removing "trim" on bx23s

I mounted my switch inside the little glove box ....



There are 3 bolts holding the plastic box to the fender.



The last one in the rear is a Biotch.



.

 

[Kmcmjmtm]

John T, that's where I was thinking about mounting mine. Have you had any issues with that location?
Thanks guys

 

[John T]

John T, that's where I was thinking about mounting mine. Have you had any issues with that location?

Thanks guys

No issues.
I believe I wired it to the 12v outlet juice ... in the box

So the lights go off When you turn the ignition switch off


Sent from my iPhone using Tapatalk Pro